Pretraživanje
Prikaz rezultata 31-40 od 59
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Electrochemical deposition and characterization of zinc-nickel alloys deposited by direct and reverse current / Elektrohemijsko taloženje i karakterizacija legura cink-nikal dobijenih konstantnom i reversnom strujom
(Serbian Chemical Society, Belgrade, 2005)
Zn-Ni alloys electrochemically deposited on steel under various deposition conditions were investigated. The alloys were deposited on a rotating disc electrode and on a steel panel from chloride solutions by direct and ...
Electrochemically deposited thin films of amorphous Fe-P alloy Part I. Chemical composition and phase structure characterization
(Elsevier Science Sa, Lausanne, 1998)
Thin Fe-P alloy films (0.5 to 25.0 mu m thick) were electrodeposited from sulfate solutions. The influences of various deposition conditions (current density, time, pH and temperature) on the composition and structure of ...
The study of Zn-Co alloy coatings electrochemically deposited by pulse current / Ispitivanje prevlaka Zn-Co legura dobijenih pulsirajućom strujom
(Association of Chemical Engineers of Serbia, 2012)
The electrochemical deposition by pulse current of Zn-Co alloy coatings on steel was examined, with the aim to find out whether pulse plating could produce alloys that could offer a better corrosion protection. The influence ...
The importance of using hydrogen evolution inhibitor during the Zn and Zn-Mn electrodeposition from ethaline
(Srpsko hemijsko društvo, Beograd, 2019)
Cyclic voltammetry was used for the characterization of zinc electro-deposition on steel from ethaline deep eutectic solution (1:2 choline chloride:ethylene glycol). The influence of 4-hydroxy-benzaldehyde (HBA) as an ...
Structural, Mechanical and Electrical Characteristics of Copper Coatings Obtained by Various Electrodeposition Processes
(Electronics, 2022)
Mechanical (hardness and adhesion) and electrical (sheet resistance) characteristics of electrolytically produced copper coatings have been investigated. Morphologies of Cu coatings produced galvanostatically at two current ...
Synergetic effect of additives on the hardness and adhesion of thin electrodeposited copper films
(Faculty of Technical Sciences in Cacak, 2017)
Thin copper films were electrodeposited on a polycrystalline cold rolled copper substrate. The composition of the laboratory-made copper sulphate electrolyte was changed by the addition of various additives. The influence ...
Ternary Zn-Ni-Co alloy: anomalous codeposition and corrosion stability
(Srpsko hemijsko društvo, Beograd, 2015)
Electrochemically deposited Zn-Ni-Co alloys under various deposition conditions were investigated using atomic absorption spectroscopy for the determination of the chemical composition, atomic force microscopy for surface ...
Electrodeposition of Ni-Mo alloy coatings and their characterization as cathodes for hydrogen evolution in sodium hydroxide solution
(Elsevier, 2008)
The hydrogen evolution reaction on the electrodeposited Ni-Mo alloy coatings, as well as their electrochemical properties in the NaOH solutions, have been investigated by the polarization measurements, cyclic voltammetry ...
Effect of temperature on the electrodeposition of disperse copper deposits / Uticaj temperature na elektrohemijsko taloženje disperznih taloga bakra
(Serbian Chemical Society, 2007)
The effect of temperature on the electrodeposition of copper at overpotentials belonging to the plateau of the limiting diffusion current density and higher was examined by the determination of the average current efficiency ...