Претраживање
Приказ резултата 31-40 од 59
Impact of roughness of Zn-Mn coatings on corrosive stability / Uticaj hrapavosti Zn-Mn prevlaka na korozionu postojanost
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
This paper involves electrochemical deposition of Zn-Mn coatings from four solutions. We measured their roughness and corrosion stability. We used cathodes made of steel of unknown composition that were licensed under the ...
The electrochemical behavior of zn-mn alloy coating in carbonated concrete solution
(World Scientific Publ Co Pte Ltd, Singapore, 2016)
In order to improve the protective performance of Zn coating on reinforcing steel in concrete, the electrochemical deposition of Zn-Mn coatings was conducted on steel surface. The morphology, chemical and phase compositions ...
The study of Zn-Co alloy coatings electrochemically deposited by pulse current / Ispitivanje prevlaka Zn-Co legura dobijenih pulsirajućom strujom
(Association of Chemical Engineers of Serbia, 2012)
The electrochemical deposition by pulse current of Zn-Co alloy coatings on steel was examined, with the aim to find out whether pulse plating could produce alloys that could offer a better corrosion protection. The influence ...
The effect of hydrogen co-deposition on the morphology of copper electrodeposits. II. Correlation between the properties of electrolytic solutions and the quantity of evolved hydrogen
(Elsevier, 2008)
Formation of irregular deposits by electrodeposition from acid sulfate solutions of various H2SO4 concentrations was examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...
Synergetic effect of additives on the hardness and adhesion of thin electrodeposited copper films
(Faculty of Technical Sciences in Cacak, 2017)
Thin copper films were electrodeposited on a polycrystalline cold rolled copper substrate. The composition of the laboratory-made copper sulphate electrolyte was changed by the addition of various additives. The influence ...
The importance of using hydrogen evolution inhibitor during the Zn and Zn-Mn electrodeposition from ethaline
(Srpsko hemijsko društvo, Beograd, 2019)
Cyclic voltammetry was used for the characterization of zinc electro-deposition on steel from ethaline deep eutectic solution (1:2 choline chloride:ethylene glycol). The influence of 4-hydroxy-benzaldehyde (HBA) as an ...
Manganese electrodeposition from urea-rich electrolyte
(Soc Chemists Technologists Madeconia, Skopje, 2015)
Pure manganese coatings were prepared on the steel (AISI 4340) electrode by a non-conventional electrodeposition method, in the presence of 8 mol dm(-3) of urea as a plating additive. The influence of urea on the ...
Ceria Particles as Efficient Dopant in the Electrodeposition of Zn-Co-CeO2 Composite Coatings with Enhanced Corrosion Resistance: The Effect of Current Density and Particle Concentration
(Molecules, 2021)
Novel Zn-Co-CeO2 protective composite coatings were deposited successfully from chloride plating solutions. Two different types of ceria sources were used and compared: commercial ceria powder and home-made ceria sol. ...
Structural, Mechanical and Electrical Characteristics of Copper Coatings Obtained by Various Electrodeposition Processes
(Electronics, 2022)
Mechanical (hardness and adhesion) and electrical (sheet resistance) characteristics of electrolytically produced copper coatings have been investigated. Morphologies of Cu coatings produced galvanostatically at two current ...
Effect of temperature on the electrodeposition of disperse copper deposits / Uticaj temperature na elektrohemijsko taloženje disperznih taloga bakra
(Serbian Chemical Society, 2007)
The effect of temperature on the electrodeposition of copper at overpotentials belonging to the plateau of the limiting diffusion current density and higher was examined by the determination of the average current efficiency ...