Претраживање
Приказ резултата 31-40 од 48
The influence of fluorine doping on the structural and electrical properties of the LiFePO4 powder
(Elsevier, 2017)
Low intrinsic electronic conductivity is the main disadvantage of LiFePO4 when used as a cathode material in lithium ion batteries. The paper offers experimental proofs of the theoretical prediction that fluorine doping ...
Spherical assemblies of titania nanotubes generated through aerosol processing
(Elsevier Sci Ltd, Oxford, 2015)
We report on the possibility to build hierarchically organized three-dimensional (3D) titania spherical particles having high surface-to-volume-ratio, by aerosol processing of nanotubular building blocks. Morphology and ...
Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping
(Elsevier Sci Ltd, Oxford, 2019)
Highly ordered, anodically grown TiO2 nanotubes on titanium supports were annealed in ammonia atmosphere in order to incorporate nitrogen doping ( lt = 2 at.%) in the titanium oxide lattice. FESEM micrographs revealed ...
Supporting information for the article: Vujančević, J., Andričević, P., Bjelajac, A., Đokić, V., Popović, M., Rakočević, Z., Horváth, E., Kollár, M., Náfrádi, B., Schiller, A., Domanski, K., Forró, L., Pavlović, V., Janaćković, Đ., 2019. Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping. Ceramics International 45, 10013–10020. https://doi.org/10.1016/j.ceramint.2019.02.045
(Ceramics International, 2019)
Table S1. Reported methods for nitrogen doping of anodized TiO2 nanotube arrays; Figure S1. SEM images and statistical distributions of outer diameters obtained by analyzing SEM micrographs of 100 nanotubes; Table S2. ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Bioactive glass-ceramics prepared by powder sintering and crystallization of polyphosphate glass containing strontium
(Elsevier Sci Ltd, Oxford, 2017)
Melt-quenching method was employed for obtaining a glass-ceramic with the following composition 42P(2)O(5). 40CaO.5SrO.10Na(2)O.3TiO(2) (mol%) glass. The crystallization and sintering behavior of glass have been studied ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Influence of annealing treatment on magnetic properties of Fe2O3/SiO2 and formation of epsilon-Fe2O3 phase
(Ceramics International, 2017)
Magnetic properties of Fe2O3/SiO2 samples were studied after being produced by sol-gel synthesis and formation of epsilon-Fe2O3 polymorph. Samples were thermally treated, using different annealing temperatures and annealing ...
Synthesis and characterization of Cr3+ doped TiO2 nanometric powders
(Elsevier, 2016)
Simple route was used for synthesis of nanostructured titania samples doped with 3 and 6 mol% of Cr3+ Titanium(IV)-isopropoxide and water were used as starting materials and as an agents for controlling hydrolysis and ...