Претраживање
Приказ резултата 3521-3530 од 3548
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Elsevier Ltd, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...
The influence of alumina crystal structures on the morphology and surface erosion of PMMA composite materials exposed to cavitation testing
(Elsevier Science Sa, Lausanne, 2019)
Composites are materials that reach many users and therefore, it is necessary to correlate the properties of every component on the behaviour of the material. Alumina is used as reinforcement with the aim of improving ...
Valorization of corn stover and molasses for enzyme synthesis, lignocellulosic hydrolysis and bioethanol production by Hymenobacter sp. CKS3
(Environmental Technology & Innovation, 2021)
During the last few decades, energy demand is increasing rapidly. Concerning this, the use of renewables - lignocellulose biomass, for bioethanol production, as an efficient alternative to replacing fossil fuels, is highly ...
Halochromic cellulose textile obtained via dyeing with biocolorant isolated from Streptomyces sp. strain NP4
(Cellulose, 2021)
Halochromic (pH-responsive) material was obtained by dyeing functionalized viscose fabric with a crude extract from Streptomyces sp. strain NP4. The functionalization of the fabric before dyeing was performed to make ...
Recovery of tungsten trioxide from waste diamond core drilling crowns by nitric acid leaching
(International Journal of Refractory Metals & Hard Materials, 2021)
A cost-effective and simple hydrometallurgy procedure for recycling the diamond core drilling crowns by nitric acid leaching, followed by the sodium hydroxide leaching, has been developed. The effect of temperature, nitric ...
Viscoelasticity and cell jamming state transition
(European Physical Journal Plus, 2021)
Although collective cell migration (CCM) is a highly coordinated migratory mode, perturbations in the form of jamming state transitions and vice versa often occur even in 2D. These perturbations are involved in various ...
Optimization of modifier deposition on the alumina surface to enhance mechanical properties and cavitation resistance
(Springer, New York, 2020)
Composites based on poly(methyl methacrylate), dimethyl itaconate matrix and alumina particles were prepared. Ferrous oxide-doped alumina particles (Al2O3Fe) and commercial alumina nanoparticles (Al(2)O(3)n) modified with ...
Advanced damage resistance monitoring procedure on the composite materials? surface-exposed to cavitation testing
(Wear, 2021)
Morphology and development of surface damage of alumina-based materials, resulting from cavitation erosion is studied in this paper. Two series of samples were prepared: samples without fibers and those with the addition ...
Synthesis and characterization of porous tungsten carbide with added tungsten silicides
(Elsevier Sci Ltd, Oxford, 2018)
Porous materials made of commercial tungsten carbide (WC) with the addition of thermally obtained tungsten silicides (WSi2 and W5Si3) were made. The main research's contribution is firstly finding optimal conditions for ...
Denture composite reinforced with short polyethylene terephthalate fibers
(John Wiley and Sons Inc., 2022)
Polymer matrix composite materials have found application in dentistry because of good mechanical properties, aesthetic, easy processing, and possibilities of the repair. Acrylates are materials used to make and repair ...