Претраживање
Приказ резултата 1-10 од 62
Epoxy coatings electrodeposited on aluminium and modified aluminium surfaces / Epoksidne kataforetske prevlake na aluminijumu i modifikovanim površinama aluminijuma
(Association of Chemical Engineers of Serbia, 2002)
The corrosion behaviour and thermal stability of epoxy coatings electrodeposited on modified aluminum surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) were monitored during exposure to 3% NaCl ...
Epoxy coatings electrodeposited on steel electrochemically modified by Zn-Co alloys / Epoksidne kataforetske prevlake na čeliku modifikovanom Zn-Co legurama
(Engineering Society for Corrosion, Belgrade, Serbia, 2003)
The corrosion behavior of epoxy coatings electrodeposited on steel and steel modified by Zn-Co alloys deposited from chloride and sulphate baths were investigated during exposure to 3 % NaCl. The electrochemical impedance ...
Electrochemical deposition and characterization of zinc-nickel alloys deposited by direct and reverse current / Elektrohemijsko taloženje i karakterizacija legura cink-nikal dobijenih konstantnom i reversnom strujom
(Serbian Chemical Society, Belgrade, 2005)
Zn-Ni alloys electrochemically deposited on steel under various deposition conditions were investigated. The alloys were deposited on a rotating disc electrode and on a steel panel from chloride solutions by direct and ...
Electrophoretic deposition of thin alumina films from water suspension
(Elsevier, Amsterdam, 2002)
Alumina water suspensions have been prepared for thin alumina film deposition on steel. The type and quantity of deflocculant have been determined using zeta potential and viscosimetric measurements. The deposition was ...
Protective properties of epoxy coatings electrodeposited on steel electrochemically modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2004)
A review is given on Zn-Ni alloys electrochemically deposited on steel under various deposition conditions. The influence of deposition current density and type of deposition solution on the chemical content, phase structure ...
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Corrosion behaviour of epoxy coatings electrodeposited on galvanized steel and steel modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2000)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on hot-dip galvanized steel and steel modified by Zn-Ni alloys were investigated during exposure to 3% NaCl solution. ...
Electrodeposition and characterization of Zn-Ni alloys as sublayers for epoxy coating deposition
(Springer, Dordrecht, 2001)
The chemical composition and phase structure of Zn-Ni alloys obtained by electrodeposition under various conditions were investigated. The influence of the deposition solution and deposition current density on the composition, ...
The electrochemical deposition and corrosion stability of Zn-Mn alloy coatings / Elektrohemijsko taloženje i koroziona stabilnost prevlaka Zn-Mn legura
(Inženjersko društvo za koroziju, Beograd, 2010)
The influence of the type of the deposition solution on the current efficiency during electrodeposition of Zn-Mn alloys was examined. The Zn-Mn alloys were deposited on steel from chloride, sulphate and pyrophosphate plating ...
Corrosion protection of aluminium by a cataphoretic epoxy coating
(Elsevier Science Sa, Lausanne, 1999)
The corrosion behavior and thermal stability of epoxy coating electrodeposited on aluminium have been investigated during exposure to 3% NaCl. Electrochemical impedance spectroscopy (EIS), gravimetric liquid sorption ...