Pretraživanje
Prikaz rezultata 31-40 od 2704
Influence of technological development on encouraging innovativeness of domestic industrial enterprises / Uticaj tehnološkog razvoja na podsticanje inovativnosti domaćih industrijskih preduzeća
(Savez ekonomista Srbije, Beograd, 2016)
Technology and technological development are the key factors of contemporary socio-economic development, and the application of the latest technological achievements is the developed countries' most powerful means of ...
Actin Cortex Rearrangement Caused by Coupling with the Lipid Bilayer-Modeling Considerations
(Springer, New York, 2015)
Studies of cell membrane fluctuations under micro rheological measurements suggest that coupling between the lipid bilayer and the actin cortex can affects viscoelastic behavior of the single cell membranes. Coupling induces ...
Some aspects of physical metallurgy of microalloyed steels
(Savez inženjera metalurgije Srbije, Beograd, 2019)
Some aspects of deformation, precipitation, and recrystallization behavior in medium carbon V-microalloyed and low carbon Nb/Ti-microalloyed steels are presented in the paper. Changes in microstructure are explained together ...
Theoretical and experimental investigation of geometry and stability of small potassium-iodide KnI (n=2-6) clusters
(Wiley, Hoboken, 2019)
Small heterogeneous potassium-iodide clusters are investigated by means of ab initio electronic structural methods together with experimental production and detection in mass spectrometry. Experiments were done by using ...
Pectin-polyvinylpyrrolidone films: A sustainable approach to the development of biobased packaging materials
(Elsevier Sci Ltd, Oxford, 2017)
In this work, the new biodegradable blend films composed of natural polymer pectin and synthetic polymer polyvinylpyrrolidone were obtained through casting process. The concentration of glycerol in all formulations was ...
Influence of intraparticle diffusion on effectiveness factor and methane selectivity of a cobalt based Fischer-Tropsch catalyst
(Amer Chemical Soc, Washington, 2019)
A terephthalate-bridged two-dimensional heteronuclear Cu(II)-Mn(II) complex with a terminal 2,2 '-dipyridylamine ligand / Хетеронуклеарни дводимензионални Cu(II)–Mn(II) комплекс са мостовним терефталат-лигандима и терминалним 2,2'-дипиридиламин- лигандом
(Srpsko hemijsko društvo, 2017)
A terephthalate-bridged heteronuclear Cu(II)-Mn(II) complex [Cu2Mn(dipya)(2)(tpht)(3)](n), I, where dipya is 2,2'-dipyridylamine and tpht is the anion of 1,4-benzenedicarboxylic (terephthalic, H(2)tpht) acid was synthesized ...
Plate heat exchanger design software for industrial and educational applications
(Savez hemijskih inženjera, Beograd, 2017)
Plate heat exchanger is a type of heat exchanger that uses corrugated metal plates to transfer heat between two fluids. The plate corrugations are designed to achieve turbulence across the entire heat transfer area thus ...
Ex-situ sensitization of ordered TiO2 nanotubes with CdS quantum dots
(Elsevier Sci Ltd, Oxford, 2015)
Ordered titania nanotubes (pore diameter approximate to 90 nm and wall thickness approximate to 10 nm) were obtained by the anodization technique and used for the ex-situ deposition of cadmium sulfide quantum dots (CdS ...
Analysis of the effects of butt welded joints on a carrying capacity of a structure tank / Analiza uticaja sučeono zavarenih spojeva na nosivost konstrukcije rezervoara
(Engineering Society for Corrosion, Belgrade, Serbia, 2017)
In the present paper, after calculation using the Finite Element Method (FEM), stress distribution on the model of a part of the pressure-tank mantle without welded joints (WJ), with transversal WJ, longitudinal WJ and ...