Претраживање
Приказ резултата 31-40 од 57
Separation of Cu(II) ions from synthetic solutions and wastewater by raw and calcined seashell waste
(Desalination Publ, Hopkinton, 2018)
The limestone and lime are agents widely used for separation of toxic metals from contaminated water. To reduce the exploitation of natural limestone deposits, appropriate replacements are sought out among the waste materials ...
Development and validation of a stability-indicating LC-UV and LC-MS/MS methods for quantitative analysis of anisomycin and identification of degradation products
(University of Sao Paulo, Conjunto Quimicas, Sao Paulo, 2018)
Multifunctional drug anisomycin was subjected to forced degradation in accordance with International Conference on Harmonisation (ICH) guidelines for the first time. The drug was exposed to the recommended stress conditions ...
Visible light absorption of TiO2 nanoparticles surface-modified with vitamin B-6: A comparative experimental and DFT study
(Srpsko hemijsko društvo, Beograd, 2018)
Surface modification of titanium dioxide nanoparticles (TiO2 NPs) with the biologically active molecule pyridoxine hydrochloride (vitamin B-6) was found to alter the optical properties. Microstructural characterization ...
Modelling of pure components high pressures densities using CK-SAFT and PC-SAFT equations
(Srpsko hemijsko društvo, Beograd, 2018)
SAFT equations of state have been widely used for the determination of different thermo-physical and phase equilibria properties. In order to use these equations as predictive models it is necessary to calculate the model ...
Removal of textile dyes from water by TiO2 nanoparticles immobilized on poly(ε-caprolactone) beads and foams
(Serbian Chemical Society, Belgrade, 2018)
This study discusses the possibility of immobilization of colloidal TiO2 nanoparticles (NPs) onto poly(ε-caprolactone) (PCL) beads and foams that could be utilized for the removal of textile dyes from water by photodegradation. ...
Influence of surface modification to mechanical and thermal properties of nanomodified acrylic dental resin
(Inst Materials Physics, Bucharest, 2018)
This paper investigated the processing and characterization of dental nanocomposites based on poly(methyl methacrylate) (PMMA) matrix reinforced with zirconium dioxide (ZrO2) nanoparticles were prepared by in-situ free ...
Degradation of nicosulfuron using fenton and fenton-like reactions
(Savez hemijskih inženjera, Beograd, 2018)
Nicosulfuron, a sulfonylurea herbicide, was subjected to different Fenton reactions at pH of a nicosulfuron aqueous solution (pH 5). Usually, the optimal pH for the Fenton reaction is between 3 and 4, but the addition of ...
Biodiesel synthesis and kinetic analysis based on MnCO3/Na silicate as heterogeneous catalyst
(Srpsko hemijsko društvo, Beograd, 2018)
The MnCO3/Na silicate (Mn/Na/Si mole ratio of 4.65:1:1.65) catalyst in the form of solid particles with diameter of 0.99-1.99 mm was used as a catalyst for transesterification of soybean oil in batch autoclave at different ...
Microfiltration with periodic gas backwashing as an alternative technique for increasing permeate flux
(Savez hemijskih inženjera, Beograd, 2018)
In this paper, the influence of operating parameters (transmembrane pressure, temperature, the flow rate of retentate) on the cross - flow microfiltration of synthetic fruit juice and periodic backwashing with air was ...
Synthesis, solvatochromism, and biological activity of novel azo dyes bearing 2-pyridone and benzimidazole moieties
(Scientific Technical Research Council Turkey-Tubitak, Ankara, 2018)
New azo dyes bearing 2-pyridone and benzimidazole moieties were prepared using diazotization of 4-(1H-benzo[d]imidazol-2-yl)aniline and coupling of the obtained diazonium salt with substituted 3-cyano-2-pyridones. Obtained ...