Претраживање
Приказ резултата 151-160 од 168
Integrity assessment of regulation system pipeline elements in hydroelectric generating set a6 of hydro power plant 'Djerdap 1'
(Society for Structural Integrity and Life, Institute for Material Testing, 2016)
Vertical Kaplan turbines with nominal power of 176 MW manufactured in Russia are installed in 6 hydroelectric generating sets at hydro power plant 'Djerdap 1' (Kladovo, Serbia). Most of the components are made of materials ...
Strength design calculation of a horizontal pressure vessel / Kontrolni proračun čvrstoće horizontalne posude pod pritiskom
(Society for Structural Integrity and Life, Institute for Material Testing, 2013)
Standards SRPS M.E2.250-262 for calculation of pres-sure vessels have been replaced by SRPS EN 13445-3. This means that calculations of new equipment and check calculations of equipment in service are subjected to ordinance ...
Complex sulphide-barite ore leaching in ferric chloride solution
(Association of Metallurgical Engineers of Serbia, 2016)
The results of research on the leaching process of complex sulphide-barite ore were presented in this paper. The leaching process was carried out in a laboratory autoclave by ferric chloride solution. Considering that those ...
Exergy concept and its implementation in the recycling of metals / Eksergijski koncept i njegova primena u recikliranju metala
(Engineering Society for Corrosion, Belgrade, Serbia, 2017)
Modern industrial product design implies presence of many different materials. Consequently, in the recycling process, shredding and separation procedures are applied. However, all materials cannot be completely separated; ...
Hydrometallurgical process for extraction of metals from electronic waste, Part I: Material characterization and process option selection
(Savez inženjera metalurgije Srbije, Beograd, 2009)
Used electronic equipment became one of the fastest growing waste streams in the world. In the past two decades recycling of printed circuit boards (PCBs) has been based on pyrometallurgy, highly polluting recycling ...
Chemical durability of sintered glass-composite prepared from glass cullet and waste foundry sand
(Metallurgical & Materials Engineering, 2021)
In this study, the glass-composite was prepared using glass cullet and waste foundry sand as raw materials. The powder technology route was employed. The mixtures containing 10-50 wt% of the sand were sintered at T = 750 ...
Influence of Cu and Mn content on the properties of Al-Mg4.5-(Mn,Cu) type alloy sheets
(Savez inženjera metalurgije Srbije, Beograd, 2009)
Influence of Cu and Mn content on the grain structure, precipitation effects and mechanical properties of two Al-Mg4.5-(Mn,Cu) type sheets was considered. It was found that a variety of grain size can be obtained in alloy ...
Hydrometallurgical process for extraction of metals from electronic waste, part II: Development of the processes for the recovery of copper from printed circuit boards (PCB)
(Savez inženjera metalurgije Srbije, Beograd, 2011)
Rapid technological development induces increase of generation of used electric and electronic equipment waste, causing a serious threat to the environment. Waste printed circuit boards (WPCBs), as the main component of ...
Solvent extraction and entrainment problem
(Association of Metallurgical Engineers of Serbia, 2020)
Applications of solvent extraction operations and processes play one of the most important roles in Hydrometallurgy. Therefore, in this brief review, some general concepts for selected representative applications are ...
The effect of mould temperature and cooling conditions on the size of secondary dendrite arm spacing in Al-7Si-3Cu alloy
(Savez inženjera metalurgije Srbije, Beograd, 2009)
The secondary dendrite arm spacing (SDAS) is one of the most important microstructure features of as-cast structure in hypoeutectic aluminum alloys. The size of SDAS depends on many factors such as liquid metal treatment, ...