Претраживање
Приказ резултата 1-10 од 17
Chemical durability of sintered glass-composite prepared from glass cullet and waste foundry sand
(Metallurgical & Materials Engineering, 2021)
In this study, the glass-composite was prepared using glass cullet and waste foundry sand as raw materials. The powder technology route was employed. The mixtures containing 10-50 wt% of the sand were sintered at T = 750 ...
Solvent extraction and entrainment problem
(Association of Metallurgical Engineers of Serbia, 2020)
Applications of solvent extraction operations and processes play one of the most important roles in Hydrometallurgy. Therefore, in this brief review, some general concepts for selected representative applications are ...
Estimation of phosphorus distribution ratio at the end of blowing in bof
(Metallurgical & Materials Engineering, 2021)
In integrated steel plants, the removal of phosphorous normally takes place during the primary basic oxygen furnace (BOF) steelmaking process. Phosphorous is usually introduced to the integrated steelmaking process through ...
Simulation of velocity profile inside turbulent boundary layer
(Association of Metallurgical Engineers of Serbia, 2020)
The second-order differential equation with a general polynomial solution [1], is adapted for simulation of complex velocity profile inside the turbulent boundary layer. Consequently, the simulation strategy is suggested.
Algorithm for quantifying the particle size distribution of non-metallic inclusions formation in steel production
(Metallurgical & Materials Engineering, 2021)
When the quantitative characterization of non-metallic inclusions in steel is done and the effect of limiting factors is assessed, and based on that the possibility of reconstruction of the total content of non-metallic ...
Effect of process parameters on the phase transformation kinetics in copper-based alloys and composites
(Metallurgical & Materials Engineering, 2020)
Copper-based alloys and composites, owing to their convenient properties, are being considered essential materials in various industries. Since copper possesses an ability to develop high corrosion resistance, putting it ...
Modeling of disperse dye adsorption on modified polyester fibers
(University of Novi Sad, Faculty of Technology, 2020)
The results of the research on the ability of adsorption of dye on polyester fibers at a temperature of 98 °C are presented in this paper. The fibers were previously modified in aqueous solutions of NaOH, KOH or Al(OH)3. ...
Cavitation resistance of basalt-based protective coatings and epoxy system
(Structural Integrity and Life-Integritet I Vek Konstrukcija, 2021)
The paper presents the results of synthesis and characterization of new refractory coatings based on basalt and epoxy system. Coatings are intended to protect the surfaces of parts of equipment and various structures in ...
Determination of the coffin-manson equation under low-cycle fatigue conditions
(Structural Integrity and Life-Integritet I Vek Konstrukcija, 2021)
The cycle loading of a material results in the modification of its properties and so in this paper is presented the behaviour of the fatigue life using low-cycle fatigue parameters. By applying the Coffin-Manson equation ...
COMPARATIVE CHEMOMETRIC ANALYSIS, RANKING AND SELECTION OF LIPOPHILICITY PARAMETERS OF 6-CHLORO-1,3,5-TRIAZINE DERIVATIVES WITH ACYCLIC AND CYCLIC SUBSTITUENTS
(University of Novi Sad, Faculty of Technology, 2022)
In the present paper, the chemometric analysis, ranking and selection of the most suitable in silico lipophilicity parameters of eight alkyl and cycloalkyl s-triazine derivatives were carried out. The lipophilicity parameters ...