Приказ резултата 1-10 од 36
Low pressure RF capacitively coupled plasma reactor for modification of seeds, polymers and textile fabrics
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
Plasma reactor operating at low pressures (0.2-1 Torr) at 13.56 MHz has been developed with an idea to optimize the treatment of polymers, biological and textile materials. The reactor proved very effective in treatment ...
The influence of oxide sol properties on the capacitive behavior of carbon supported hydrous ruthenium oxide
(Progress in Advanced Materials and Processes: Proceedings of the Fifth Jugoslav Materials Research Society, YUCOMAT V, 2004)
Carbon supported hydrous ruthenium oxide was prepared by ail ultrasonic threatment of carbon black-RuOxHy sol mixture (impregnation). Black Pearl 2000(R) was used as a supporting material, while an oxide sol was prepared ...
Influence of Cu on the mechanical properties of an Al-4.4wt%Mg alloy after ECAP
(Trans Tech Publications, Ltd., 2006)
Two Aluminium alloys, type AA5182 and AA5182+1.2wt% Cu, have been studied. The
second alloy in solution treated condition is 18% stronger than the first one. During ageing at 150°C or 200°C it shows a characteristic fast ...
Hydrogen evolution reaction from EDTA solutions
(4th Conference of the Yugoslav Materials Research Society, 2002)
An attempt was made to investigate the mechanism and kinetics of hydrogen evolution reaction on zinc and platinum wire electrodes from solutions containing ethylene diamine tetraacetic acid (EDTA). EDTA is a tetra-basic ...
Investigation of antimicrobial activity of encapsulated essential oils
(8th Conference of the Yugoslav Materials Research Society, 2007)
Antimicrobial activity of essential oils obtained from many plants has been known for a long time. However, the use of essential oils as active components of biomedical textile have recently gained popularity and aroused ...
Numerical and analytical modeling of elastic-plastic fracture mechanics parameters
(8th Conference of the Yugoslav Materials Research Society, 2007)
Structural integrity and service reliability depend on the fracture resistance of a material. Cracks in the material are the locations of stress concentration, and elastic-plastic deformation can occur causing the development ...
Comparative potentiodynamic study of nickel and hydrogen underpotential deposition at polycrystalline platinum electrode in weak acid and neutral solutions
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
Underpotential deposition of nickel and hydrogen on polycrystalline platinum in weak acid and neutral solutions (3.5 lt = pH lt = 7.0), with and without Ni2+-ions, has been examined using cyclic voltammetric technique ...
Chain conformational statistics and mechanical properties of elastomer composites
(Progress in Advanced Materials and Processes: Proceedings of the Fifth Jugoslav Materials Research Society, YUCOMAT V, 2004)
A new equation of state for elastomer network under constrains due to fillers has been proposed and verified for two most common and industry important rubbers, natural rubber and styrene-butadiene rubber. A series of ...
Theoretical assessment of calcium arsenates stability: Application in the treatment of arsenic contaminated waste
(8th Conference of the Yugoslav Materials Research Society, 2007)
Several approaches for immobilization of arsenic (As) based on the transformation of its soluble forms (compounds) into highly insoluble arsenate apatite Ca5(AsO4)3 OH have been proposed. These immobilization techniques ...
Properties of dispersion-hardened copper made by internal oxidation of prealloyed copper powder containing 2.5wt. % Al
(6th Conference of the Yugoslav Materials Research Society, YUCOMAT VI: Current Research in Advanced Materials and Processes, 2005)
Prealloyed copper powder containing 2.5wt. %Al was processed in a planetary ball mill to evaluate matrix hardening due to formation of Al2O 3 particles in situ by internal oxidation. After milling, the powders were heat ...