Претраживање
Приказ резултата 1-10 од 743
Artificial neural network data analysis for classification of soils based on their radionuclide content
(Maik Nauka/Interperiodica/Springer, New York, 2007)
The artificial neural network (ANN) data analysis method was used to recognize and classify soils of an unknown geographic origin. A total of 103 soil samples were differentiated into classes according to the regions in ...
Bioactive glass-apatite composite coating for titanium implant synthesized by electrophoretic deposition
(Elsevier Sci Ltd, Oxford, 2007)
Titanium and titanium alloys are widely used as materials for implants, because of their mechanical properties and nontoxic behaviour, but unfortunately, are bioinert. In order to solve this problem, the metal implant could ...
Influence of formation conditions and precursor viscosity on mean fiber diameter formed using the relating disk method
(Elsevier, Amsterdam, 2000)
Alumina ceramic fibers were produced from aluminum-hydroxidechloride based sol. Polyvinyl alcohol and surface active material were applied to adjust the rheological characteristics of the: sol. The rotating disk formation ...
Stress analysis in hydroxyapatite/poly-L-lactide composite biomaterials
(Elsevier, Amsterdam, 2001)
A three-dimensional (3D) finite element (FE) analysis of the stress concentration factor (SCF) in biocomposite model cell has been performed. The model composite consisted of a hydroxyapatite hard particle (HAp) embedded ...
Refining of corrosive insulating oils by selective liquid-liquid extraction process
(42nd International Conference on Large High Voltage Electric Systems 2008, CIGRE 2008, 2008)
In recent years copper sulphide formation in transformer windings has been recognized as one significant risk factor for operation of power transformers, due to number of failures which have occurred as a consequence of ...
Oxygen transport in tissue engineering systems: Cartilage and myocardium
(Fluid Dynamics and Materials Processing, 2007)
Efficient transport of oxygen is one of the main requirements in tissue engineering systems in order to avoid cell death in the inner tissue regions and support uniform tissue regeneration. In this paper, we review approaches ...
Doped gamma-Bi2O3: synthesis of microcrystalline samples and crystal chemical analysis of structural data
(Walter de Gruyter Gmbh, Berlin, 2007)
A series of microcrystalline products containing the gamma-Bi2O3 phase doped with Co, Fe, Mn, Pb, Sb, Si, Ti, V and Zn has been prepared by solid state reaction. Based on the heating temperature and heating time, the ...
Study of chlorination of nickel ferrite by gaseous chlorine and calcium chloride in the presence of active additives
(Wiley, Hoboken, 2000)
Thermodynamic analysis and experimental research of the chlorination of nickel ferrite (NiFe2O4) by gaseous chlorine in the presence of added C, BaS, S and NaCl in the temperature range from 300 to 900 degrees C are given ...
Predictive modeling of the mechanical properties of particulate hydroxyapatite reinforced polymer composites
(Wiley, Hoboken, 2002)
The influence of particle geometry and volume fraction on the mechanical properties of a hydroxyapatite (HAp) particulate reinforced polymer (poly-L-lactide and collagen) matrix composite was investigated through finite-element ...
Characterization of alumina films electrodeposited on steel from water suspensions
(InterCeram: International Ceramic Review, 2003)
Alumina films were electrodeposited on steel from water suspensions using the constant voltage method. The morphology of deposited films was investigated using optical microscopy coupled with image analysis which enabled ...