Претраживање
Приказ резултата 31-40 од 168
Analysis of the effects of butt welded joints on a carrying capacity of a structure tank / Analiza uticaja sučeono zavarenih spojeva na nosivost konstrukcije rezervoara
(Engineering Society for Corrosion, Belgrade, Serbia, 2017)
In the present paper, after calculation using the Finite Element Method (FEM), stress distribution on the model of a part of the pressure-tank mantle without welded joints (WJ), with transversal WJ, longitudinal WJ and ...
Behaviour of nionikral-70 in low-cycle fatigue
(Society for Structural Integrity and Life, Institute for Material Testing, 2017)
Experimental research on the behaviour of high-strength low-alloy steel ( HSLA)exposed to low-cycle fatigue (LCF) with controlled and fully reversible strain (Delta epsilon/2 = const, R epsilon =epsilon(min)/epsilon(max) ...
Photocatalytic degradation of carbamate insecticides: Effect of different parameters / Fotokatalitička degradacija karbamatnih insekticida - efekti različitih parametara
(Institute of Pesticides and Environmental Protection, 2019)
Photocatalytic degradation of a model compound of the carbamate insecticide carbofuran in water was studied using polychromatic light and ZnO and TiO2 catalysts. The influence of operational parameters, such as reaction ...
Preservation of vitamin C, lycopene and carbohydrate content in tomato dried in a tunnel type dryer / Očuvanje vitamina C, likopena i ugljenih hidrata u plodovima paradajza sušenim u tunelskom tipu sušara
(Institute for Food Technology, Novi Sad, 2017)
The aim of this study was to find an optimal way of tomato drying in a tunnel type dryer, in order to achieve the lowest possible losses in nutritive value of dried tomato products. Domestic variety of tomato (SP-109) was ...
Estimation of phosphorus distribution ratio at the end of blowing in bof
(Metallurgical & Materials Engineering, 2021)
In integrated steel plants, the removal of phosphorous normally takes place during the primary basic oxygen furnace (BOF) steelmaking process. Phosphorous is usually introduced to the integrated steelmaking process through ...
Significance and applicability of structural integrity assessment / Značaj i primenljivost ocene integriteta konstrukcija
(Society for Structural Integrity and Life, Institute for Material Testing, 2012)
To avoid unexpected and frequent serious failures of objects and equipment in service, and save their structural integrity, proper experimental and theoretical analyses are required, that are supported by modeling and ...
Tailoring the corrosion resistance of Zn-Mn coating by electrodeposition from deep eutectic solvents / Poboljšanje korozione postojanosti Zn-Mn prevlake, elektrohemijskim taloženjem iz dubokih eutektičkih smeša
(Engineering Society for Corrosion, Belgrade, Serbia, 2018)
Well adhered, homogenous coatings were obtained from deep eutectic solvents (DES) based on choline chloride and urea, at current densities up to 20 mA cm-2. The coatings' morphology was analyzed by atomic force microscopy, ...
Numerical simulation of temperature field in the vertical bridgman method crystal growth
(Savez inženjera metalurgije Srbije, Beograd, 2015)
The mathematical model for heat transfer during the Bridgeman crystal growth, using the finite element method and the obtained result are presented. Some modifications to the method were introduced in order to incorporate ...
Micromechanical crack analysis of glass-epoxy laminated composites subjected to tension load / Mikromehanička analiza loma laminatnog staklo-epoksi kompozitnog materijala ispitivanog na zatezanje
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
The main objective of this study is to determine tensile properties of the glass-epoxy polymer composite material. The material is glass fiber 280 g/m², 'twill woven' with 100 cm width, type - Interglas 92125, and epoxy ...
The influence of light on corrosion of polyaniline coated mild steel / Uticaj osvetljenosti na koroziju mekog čelika sa prevlakom polianilina
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
The influence of light of the mild steel corrosion in 3% NaCl solution with polyaniline coating based on the possibilities that polyaniline can generate photoelectrons, even in the laboratory conditions has been investigated.