Претраживање
Приказ резултата 21-30 од 187
Tailoring the physico-chemical and antimicrobial properties of agar-based films by in situ formation of Cu-mineral phase
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
New agar-based composite films with increasing Cu-carbonate and Cu-phosphate mineral phase content were prepared by in situ mineralization and solvent casting method. SEM and optical analysis revealed that Cu-carbonate ...
Leaching of toxic elements from secondary alkaline lead slag and stabilized/solidified products
(Springer, New York, 2019)
Secondary alkaline lead slag (SALS), generated during lead-acid batteries recycling, is a hazardous waste due to its high reactivity, solubility, and migration of toxic elements. After pulverization caused by storage under ...
Non-thermal plasma and ultrasound-assisted open lactic acid fermentation of distillery stillage
(Springer Heidelberg, Heidelberg, 2019)
Stillage is the main by-product of bioethanol production and the cost of its treatment significantly affects the economy of bioethanol production. A process of thermal sterilization before lactic acid fermentation (LAF) ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Inventive level as a basis for the assessment of scientific contribution of inventors / Inventivni nivo pronalaska kao osnov za procenu naučnog doprinosa pronalazača
(University of Belgrade - Faculty of Mechanical Engineering, Belgrade, 2019)
The history of invention reveals that the most important inventions were derived from experiments by which their authors contributed to the discovery of previously unknown natural phenomena. So the question arises as to ...
Salt template zirconia reinforcing particles as possible reinforcement for PMMA matrix composite
(Sage Publications Ltd, London, 2019)
To obtain flakes like zirconia particles at relatively low temperature, the synthesis method for producing zirconia particles on the surface of salt particles that serve as a template is examined. The produced particles ...
Removal of emerging pathogenic bacteria using metal-exchanged natural zeolite bead filter
(Iwa Publishing, London, 2019)
Hospital wastewaters can become a route for dissemination of antibiotic-resistant bacteria to the environment if not properly treated. Some of these bacteria are able to survive conventional disinfection treatments (e.g. ...
Influence of different concentrations of Zn-carbonate phase on physical-chemical properties of antimicrobial agar composite films
(Elsevier, Amsterdam, 2019)
Agar-based composites with different Zn-carbonate mineral phase content were prepared by in situ mineralization and the solvent casting method. The mineral phase within the composite films was identified as hydrozincite, ...
Doping of TiO2 nanotubes with nitrogen by annealing in ammonia for visible light activation: Influence of pre- and post-annealing in air
(Elsevier Science Sa, Lausanne, 2019)
The similar to 60 nm wide and similar to 2 mu m long TiO2 nanotubes were obtained by anodization of Ti films sputtered on F-doped tin oxide glass. For N-doping the samples were annealed in ammonia atmosphere. The effect ...
The influence of alumina particle modification on the adhesion of the polyacrylate matrix composite films and the metal substrate
(Taylor & Francis Ltd, Abingdon, 2019)
Adhesion behavior between the composite films, consisting of UV cured Bis-GMA (Bisphenol A glycidylmethacrylate)/TEGDMA (triethylene glycol dimethacrylate) as a matrix and the ferrous oxide doped alumina particles, Al2O3 ...