Претраживање
Приказ резултата 11-20 од 22
Visible-light active mesoporous, nanocrystalline N,S-doped and co-doped titania photocatalysts synthesized by non-hydrolytic sol-gel route
(Elsevier Sci Ltd, Oxford, 2016)
Visible-light active mesoporous N,S-doped and co-doped anatase TiO2 powders were synthesized by non-hydrolytic sol-gel route, starting from TiCl4 and Ti((OPr)-Pr-i)(4) dissolved in cyclohexane or dimethyl sulfoxide, later ...
CdS quantum dots sensitized TiO2 nanotubes by matrix assisted pulsed laser evaporation method
(Elsevier Sci Ltd, Oxford, 2016)
Within this study a matrix assisted pulsed laser evaporation technique was employed for deposition of CdS quantum dots onto TiO2 nanotubes. The number of laser pulses and laser fluence were varied to control the amount of ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Supporting information for the article: Vujančević, J., Andričević, P., Bjelajac, A., Đokić, V., Popović, M., Rakočević, Z., Horváth, E., Kollár, M., Náfrádi, B., Schiller, A., Domanski, K., Forró, L., Pavlović, V., Janaćković, Đ., 2019. Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping. Ceramics International 45, 10013–10020. https://doi.org/10.1016/j.ceramint.2019.02.045
(Ceramics International, 2019)
Table S1. Reported methods for nitrogen doping of anodized TiO2 nanotube arrays; Figure S1. SEM images and statistical distributions of outer diameters obtained by analyzing SEM micrographs of 100 nanotubes; Table S2. ...
Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping
(Elsevier Sci Ltd, Oxford, 2019)
Highly ordered, anodically grown TiO2 nanotubes on titanium supports were annealed in ammonia atmosphere in order to incorporate nitrogen doping ( lt = 2 at.%) in the titanium oxide lattice. FESEM micrographs revealed ...
Sr,Mg co-doping of calcium hydroxyapatite: Hydrothermal synthesis, processing, characterization and possible application as dentin substitutes
(Ceramics International, 2022)
The aim of this study was to investigate the influence of binary Sr, Mg ion-doping compared to the single-ion doping effects on the phase composition and morphology of hydrothermally obtained calcium hydroxyapatite (HAP) ...
Effect of YAG content on creep resistance and mechanical properties of Al2O3-YAG composite
(Elsevier Sci Ltd, Oxford, 2020)
Comprehensive study on effect of YAG amount on densification, creep resistance and room-temperature mechanical properties of Al2O3-YAG composite pressureless sintered at 1600 degrees C was conducted. The main goal was to ...
Mechanical properties and thermal shock resistance of anorthite ceramics obtained by slip casting
(Elsevier Ltd., 2024)
Anorthite ceramics (CaAl2Si2O8) was obtained by slip casting of water suspension of kaolin (Al2O3·2SiO2·2H2O) and CaCO3 as a source of CaO. A relative density of 87 % of the theoretical density was achieved after a 3-h-long ...
Synthesis of pure and La-doped anatase nanopowders by sol-gel and hydrothermal methods and their efficiency in photocatalytic degradation of alprazolam
(Elsevier Ltd., 2014)
Pure and La3+ doped titanium dioxide (TiO2) nanopowders were obtained by sol gel and hydrothermal methods. A precursor was titanium tetrachloride and concentrations of dopants were 0.5 and 1.0 mol%. Procedures of both ...
Structural and morphological characterization of iron-doped sol-gel derived mullite powders
(Elsevier Sci Ltd, Oxford, 2020)
The structural and morphological properties of iron-doped mullite powders are the subject of the present study. The powders of undoped and iron-doped mullite in the composition range of 3-15 wt% Fe2O3 were synthesized by ...