Претраживање
Приказ резултата 1-10 од 15
Ag+, Cu2+ and Zn2+ doped hydroxyapatite/tricalcium phosphate bioceramics: Influence of doping and sintering technique on mechanical properties
(University of Novi Sad, Faculty of Technology, 2018)
Green hydroxyapatite ceramics were obtained by cold uniaxial and isostatic pressing of hydrothermally synthesized powders, pure hydroxyapatite and hydroxyapatite doped with Ag+, Cu2+ and Zn2+ ions. The ceramics were ...
Nimonic 263 microstructure and surface characterization after laser shock peening
(Croatian Metallurgical Soc, Zagreb, 2015)
The Laser Shock Peening (LSP) is applied to the surface of Nimonic 263 alloy. The changes in microstructure and surface topography are observed and analyzed by Scanning Electron Microscopy (SEM), profilometer and microhardness ...
The tribological performance of hardfaced/thermal sprayed coatings for increasing the wear resistance of ventilation mill working parts
(Univerzitet u Kragujevcu - Fakultet inženjerskih nauka, Kragujevac, 2015)
During the coal pulverizing, the working parts of the ventilation mill are being worn by the sand particles. For this reason, the working parts are usually protected with materials resistant to wear (hardfaced/thermal ...
Examination of the adhesion of polymer composite films based on Bis-GMA/TEGDMA on different metal substrates / Ispitivanje adhezije polimernih kompozitnih filmova na bazi Bis-GMA/TEGDMA na različitim metalnim podlogama
(Savez inženjera i tehničara Srbije, Beograd, 2018)
The subject of this study is the quantitative adhesion of a UV-curing composite film based on Bis-GMA (Bisphenol A glycidylmethacrylate) / TEGDMA (triethylene glycol dimethacrylate) as a matrix and particles doped with ...
Influence of picosecond laser pulses on the microstructure of austenitic materials
(Springer, New York, 2011)
We investigate samples of austenitic materials - stainless steel and iron-based superalloy - which are widely used at high temperatures and pressures. The samples were exposed to Nd(3+):YAG laser pulses with a wavelength ...
Examination of mechanical properties of acrilyc composite materials with different AL2O3 reinforcement by brazil test / Ispitivanje mehaničkih svojstava akrilatnih kompozitnih materijala sa različitim AL2O3 ojačanjima brazilskim testom
(Savez inženjera i tehničara Srbije, Beograd, 2019)
Composite materials based on UV-curing acrylates and various alumina-based reinforcements represent material that is suitable for the use in dentistry, but also in other areas. Composites were made using four different ...
Picosecond laser shock peening of base Nimonic 263 material and laser welded Nimonic 263 alloy / Mehanička obrada pikosekundnim laserom osnovnog materijala i zavarenih spojeva legure Nimonik 263
(DUZS - Društvo za unapređivanje zavarivanja u Srbiji, Beograd, 2015)
Laser welding is a welding process with a high energy density and numerous advantages over conventional welding methods (narrow heat affected zone, lower heat input, less distortion, and the like.) Mechanical treatment ...
Analysis of mechanical and structural properties of micro alloyed steel welded joints depending on quality of cored wire
(University of Osijek, Tech Fac, Slavonski Brod, 2013)
The aim of this study was to master new quality cored wires made of steel strips and the cores filled with metal powders and low molecular hydrophobic compounds. For experimental research, the specimens were made of micro ...
Characterization of vacuum plasma spray NiCoCrAlY coating resistant to high temperature oxidation / Karakterizacija vakuum plazma sprej prevlake NiCoCrAlY otporne na visokotemperaturnu oksidaciju
(Engineering Society for Corrosion, Belgrade, Serbia, 2019)
Protective vacuum plasma spray VPS - NiCoCrAlY coating is used on sections of gas turbines to allow for longer and more reliable operation of sections exposed to aggressive effects of high temperature oxidation. Depositing ...
Characterization of plasma spray bioinert coating Al2O328wt.%MgO / Karakterizacija plazma sprej bioinertne prevlake Al2O328tež.%MgO
(Engineering Society for Corrosion, Belgrade, Serbia, 2019)
This paper presents the results of testing mechanical and structural characteristics of plasma spray coating Al2O328wt.%MgO. Metal oxide MgO in a complex oxide Al2O328wt.%MgO modifies the properties of Al2O3 ceramics by ...