Pretraživanje
Prikaz rezultata 11-20 od 62
Hydrogen evolution on Ni/WC composite coatings
(Springer, 2006)
The catalytic activity for the hydrogen evolution reaction (HER) of Ni/WC composites obtained by electrochemicaldeposition of nickel from a conventional Watt’s bath, using two different ways of depositing the WC particles, ...
Electrochemically deposited thin films of amorphous Fe-P alloy Part I. Chemical composition and phase structure characterization
(Elsevier Science Sa, Lausanne, 1998)
Thin Fe-P alloy films (0.5 to 25.0 mu m thick) were electrodeposited from sulfate solutions. The influences of various deposition conditions (current density, time, pH and temperature) on the composition and structure of ...
Electrochemical deposition and characterization of zinc-nickel alloys deposited by direct and reverse current / Elektrohemijsko taloženje i karakterizacija legura cink-nikal dobijenih konstantnom i reversnom strujom
(Serbian Chemical Society, Belgrade, 2005)
Zn-Ni alloys electrochemically deposited on steel under various deposition conditions were investigated. The alloys were deposited on a rotating disc electrode and on a steel panel from chloride solutions by direct and ...
Electrophoretic deposition of thin alumina films from water suspension
(Elsevier, Amsterdam, 2002)
Alumina water suspensions have been prepared for thin alumina film deposition on steel. The type and quantity of deflocculant have been determined using zeta potential and viscosimetric measurements. The deposition was ...
Protective properties of epoxy coatings electrodeposited on steel electrochemically modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2004)
A review is given on Zn-Ni alloys electrochemically deposited on steel under various deposition conditions. The influence of deposition current density and type of deposition solution on the chemical content, phase structure ...
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Corrosion behaviour of epoxy coatings electrodeposited on galvanized steel and steel modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2000)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on hot-dip galvanized steel and steel modified by Zn-Ni alloys were investigated during exposure to 3% NaCl solution. ...
The electrochemical deposition and corrosion stability of Zn-Mn alloy coatings / Elektrohemijsko taloženje i koroziona stabilnost prevlaka Zn-Mn legura
(Inženjersko društvo za koroziju, Beograd, 2010)
The influence of the type of the deposition solution on the current efficiency during electrodeposition of Zn-Mn alloys was examined. The Zn-Mn alloys were deposited on steel from chloride, sulphate and pyrophosphate plating ...
Corrosion behaviour of epoxy coatings on modified aluminium surfaces
(Bulletin of Electrochemistry, 2002)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on aluminium and modified aluminium surfaces (anodized phosphatized and chromatized-phosphatized aluminium) have been ...
The effect of hydrogen co-deposition on the morphology of copper electrodeposits. II. Correlation between the properties of electrolytic solutions and the quantity of evolved hydrogen
(Elsevier, 2008)
Formation of irregular deposits by electrodeposition from acid sulfate solutions of various H2SO4 concentrations was examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...