Pretraživanje
Prikaz rezultata 31-40 od 62
Corrosion behaviour of epoxy coatings investigated by EIS
(Trans Tech Publications Ltd, Durnten-Zurich, 1998)
Epoxy coatings were formed by cathodic electrodeposition of an epoxy resin on steel and on electrochemically modified steel surface by Fe-P alloy using constant voltage method (resin concentration 10 wt.%, temperature 26 ...
Determination of the protective properties of electrodeposited organic epoxy coatings on aluminium and modified aluminium surfaces
(Pergamon-Elsevier Science Ltd, Oxford, 2005)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on aluminium and modified aluminium surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) have been ...
Study of thermal stability of epoxy coatings electrodeposited on different substrates
(Elsevier Sci Ltd, Oxford, 1999)
The thermal stability of epoxy coatings electrodeposited on steel, phosphatized steel, steel electrochemically modified by Zn-Ni alloys and aluminium has been investigated. Epoxy coatings were formed by cathodic electrodeposition ...
The electrochemical behavior of zn-mn alloy coating in carbonated concrete solution
(World Scientific Publ Co Pte Ltd, Singapore, 2016)
In order to improve the protective performance of Zn coating on reinforcing steel in concrete, the electrochemical deposition of Zn-Mn coatings was conducted on steel surface. The morphology, chemical and phase compositions ...
The study of Zn-Co alloy coatings electrochemically deposited by pulse current / Ispitivanje prevlaka Zn-Co legura dobijenih pulsirajućom strujom
(Association of Chemical Engineers of Serbia, 2012)
The electrochemical deposition by pulse current of Zn-Co alloy coatings on steel was examined, with the aim to find out whether pulse plating could produce alloys that could offer a better corrosion protection. The influence ...
Microindentation hardness testing of different composite systems with thin electrodeposited nickel and copper films
(Belgrade : Military Technical Institute, 2012)
Thin Ni and Cu films with fine-grained structures have been electrodeposited from self-made sulphamate-based and sulphate-based electrolytes, respectively. DC electrodeposition of Ni films was performed on single crystal ...
Synergetic effect of additives on the hardness and adhesion of thin electrodeposited copper films
(Faculty of Technical Sciences in Cacak, 2017)
Thin copper films were electrodeposited on a polycrystalline cold rolled copper substrate. The composition of the laboratory-made copper sulphate electrolyte was changed by the addition of various additives. The influence ...
Ceria Particles as Efficient Dopant in the Electrodeposition of Zn-Co-CeO2 Composite Coatings with Enhanced Corrosion Resistance: The Effect of Current Density and Particle Concentration
(Molecules, 2021)
Novel Zn-Co-CeO2 protective composite coatings were deposited successfully from chloride plating solutions. Two different types of ceria sources were used and compared: commercial ceria powder and home-made ceria sol. ...
Structural, Mechanical and Electrical Characteristics of Copper Coatings Obtained by Various Electrodeposition Processes
(Electronics, 2022)
Mechanical (hardness and adhesion) and electrical (sheet resistance) characteristics of electrolytically produced copper coatings have been investigated. Morphologies of Cu coatings produced galvanostatically at two current ...
Effect of temperature on the electrodeposition of disperse copper deposits / Uticaj temperature na elektrohemijsko taloženje disperznih taloga bakra
(Serbian Chemical Society, 2007)
The effect of temperature on the electrodeposition of copper at overpotentials belonging to the plateau of the limiting diffusion current density and higher was examined by the determination of the average current efficiency ...