Pretraživanje
Prikaz rezultata 11-20 od 1452
Method for determining refractory specimen heat resistance
(Springer, New York, 2008)
The most important properties governing the operation of refractories are refractoriness, service temperature and heat resistance. The heat resistance of specimens based on Al2O3 is determined by a standard laboratory ...
Synthesis and settings behavior of alpha-TCP from calcium deficient hyroxyapatite obtained by hydrothermal method
(Natl Inst Optoelectronics, Bucharest-Magurele, 2007)
The aim of this work is the investigation of alpha-tricalcium-phosphate (alpha-TCP) formation from calcium-deficient hydroxyapatite (CDHAP), synthesized by hydrothermal method from CaCl2, EDTA, NaH2PO4 center dot 2H(2)O ...
Sintering behaviour of nanosized HAP powder
(Trans Tech Publications Ltd, Durnten-Zurich, 2007)
The influences of temperature and time on sintering behaviour of nanosized HAP powder were investigate in this paper. The calcium hydroxyapatite powder, with the average crystallite size of 34 +/- 1 nm, was uniaxially ...
Imobilizacija lipaze iz candida rugosa u alginatne čestice upotrebom elektrostatičkog generatora
(Univerzitet u Nišu - Tehnološki fakultet, Leskovac, 2002)
Supercritical carbon dioxide extraction of antioxidants from rosemary (Rosmarinus officinalis L.) and sage (Salvia officinalis L.) / Natkritična ekstrakcija antioksidanasa iz ruzmarina (Rosmarinus officinalis L.) i žalfije (Salvia officinalis L.)
(Serbian Chemical Society, Belgrade, 2009)
The aim of the present study was to isolate and characterize antioxidant extracts obtained from dried leaves of rosemary (Rosmarinus officinalis L.) and sage (Salvia officinalis L.), originating from the southern Balkan ...
Electrochemical deposition and characterization of Zn-Co alloys and corrosion protection by electrodeposited epoxy coating on Zn-Co alloy
(Pergamon-Elsevier Science Ltd, Oxford, 2002)
Zn-Co alloys electrochemically deposited on steel under various deposition conditions were investigated. The influence of deposition current density, temperature and composition of deposition solution on the phase structure ...
Embedding of optical fibers as sensors in thermoplastic composite laminates / Ugradnja optičkih vlakana kao senzora u slojevite termoplastične kompozitne materijale
(Institut bezbednosti, Beograd, 2003)
Application of optical fibers as sensors for the purpose of in-service health monitoring in composite materials have increased in last few years. Advantages of optical fiber sensors over conventional sensing methods are ...
Drying of the aqueous extract of acorn Quercus robur in a spout-fluid bed / Sušenje vodenog ekstrakta hrastovog žira Quercus robur u sušioniku sa fontansko-fluidizovanim slojem
(University of Belgrade - Faculty of Agriculture, Belgrade, 2005)
The results of the chemical investigations of variously treated acorn samples are presented in this paper with the aim of obtaining data on the amount of nutritious components and biologically active substances. The Quercus ...
Biocompatible and bioadhesive hydrogels based on 2-hydroxyethyl methacrylate, monofunctional poly(alkylene glycol)s and itaconic acid
(Springer, New York, 2006)
Novel poly(Bisomer/HEMA/IA) hydrogels were prepared by radical copolymerization of poly(alkylene glycol) (meth)acrylates, i.e. short chains Bisomers, 2-hydroxyethyl methacrylate (HEMA) and itaconic acid (IA) in a mixture ...
Characterization of dispersion strengthened copper with 3wt%Al2O3 by mechanical alloying
(International Institute for the Science of Sintering, Beograd, 2004)
The copper matrix has been dispersion strengthened with 3wt.%Al2O3 by mechanical alloying. Commercial alumina powder with an average particle size of 0.75mm was used for alloying. The mechanical alloying process was performed ...