Претраживање
Приказ резултата 41-50 од 59
Supporting information for the article: Vujančević, J., Andričević, P., Bjelajac, A., Đokić, V., Popović, M., Rakočević, Z., Horváth, E., Kollár, M., Náfrádi, B., Schiller, A., Domanski, K., Forró, L., Pavlović, V., Janaćković, Đ., 2019. Dry-pressed anodized titania nanotube/CH3NH3PbI3 single crystal heterojunctions: The beneficial role of N doping. Ceramics International 45, 10013–10020. https://doi.org/10.1016/j.ceramint.2019.02.045
(Ceramics International, 2019)
Table S1. Reported methods for nitrogen doping of anodized TiO2 nanotube arrays; Figure S1. SEM images and statistical distributions of outer diameters obtained by analyzing SEM micrographs of 100 nanotubes; Table S2. ...
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Bioactive glass-ceramics prepared by powder sintering and crystallization of polyphosphate glass containing strontium
(Elsevier Sci Ltd, Oxford, 2017)
Melt-quenching method was employed for obtaining a glass-ceramic with the following composition 42P(2)O(5). 40CaO.5SrO.10Na(2)O.3TiO(2) (mol%) glass. The crystallization and sintering behavior of glass have been studied ...
Nanoindentation study of nickel manganite ceramics obtained by a complex polymerization method
(Elsevier Sci Ltd, Oxford, 2016)
The chemical synthesis of nickel manganite powder was performed by a complex polymerization method (CPM). The obtained fine nanoscaled powders were uniaxially pressed and sintered at different temperatures: 1000-1200 degrees ...
Mechanical activation of talc in high-energy speed rotary mechanoactivator
(Elsevier LtdTechna Group S.r.l., 2012)
This paper presents the results of research on mechanical activation of raw talc in a high-energy speed rotary mechanoactivator. The results of research on effect of mechanically activated talc on the degree of recovery ...
Optimization of the production process through response surface method: Bricks made of loess
(Elsevier, 2013)
Loess clays are commonly used to produce bricks. Heavy clays, taken at location near Zrenjanin, Serbia, are used as a representative raw material in this study. The sample, containing about 28% of clay sized particles, is ...
Shape and aspect ratio analysis of anisotropic magnetic nanochains based on TEM micrographs
(Ceramics International, 2018)
Due to advances in electron microscopy and to the development of novel nanoparticle structures with different morphologies and the dependence of physical properties on the nanoparticle morphology, there is a need for a ...
Tuning of BiFeO3 multiferroic properties by light doping with Nb
(Elsevier Sci Ltd, Oxford, 2018)
Bulk ceramic samples of BiFeO3 were light doped (up to 1%) with Nb5+ in the place of Fe3+ (B-site doping) and their multiferroic properties were investigated using XRD, SEM, polarization (PMTS) and magnetization (SQUID) ...
Sr,Mg co-doping of calcium hydroxyapatite: Hydrothermal synthesis, processing, characterization and possible application as dentin substitutes
(Ceramics International, 2022)
The aim of this study was to investigate the influence of binary Sr, Mg ion-doping compared to the single-ion doping effects on the phase composition and morphology of hydrothermally obtained calcium hydroxyapatite (HAP) ...