Претраживање
Приказ резултата 61-70 од 149
Investigation of copper(i) sulphide leaching in oxidative hydrochloric acid solution
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Present work is focused on the copper (I) sulphide leaching with sodium chloride in hydrochloric acid solution and with introduction of gaseous oxygen. Chemical reactions of leaching and their thermodynamic probabilities ...
Basic principles and applications of photoelectrochemical reactions / Osnovni principi i primena fotoelektrohemijskih reakcija
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
The paper discusses the basic principles of photoelectrochemistry and photo electrochemical reactions. Considered the application photoelectrochemicl cells in the conversion of the sun iradiation energy into electricity. ...
Influence of acidic solutions on the strain distribution in glasspolyester composite pipes subjected to internal pressure / Uticaj rastvora kiselina na raspodelu deformacija kod staklo-poliestar kompozitnih cevi istaloženih dejstvu unutrašnjeg pritiska
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
The basic subject of this paper was the determination of the strain distribution in glass-polyester composite pipes subjected to internal pressure. Firstly, the test was performed on virgin pipe segments (without the ...
Oxidation and erosion behaviour of SiC-HfC multilayered composite
(Univerzitet u Novom Sadu - Tehnološki fakultet, Novi Sad, 2014)
The fabrication of SiC-HfC ceramic composite via self-propagating high-temperature synthesis and simultaneous consolidation was investigated. Dense composite consisting of alternating layers of SiC and HfC was obtained by ...
Microstructural properties and cavitation behavior of hypereutectic Al-Si alloy obtained by rheocasting process / Mikrostrukturna svojstva i kavitaciono ponašanje nadeutektičke Al-Si legure dobijene reokasting postupkom
(Engineering Society for Corrosion, Belgrade, Serbia, 2014)
The purpose of this study was to investigate possible application of AlSi alloy produced by rheocasting process in cavitation conditions. A rheocasting process was used to refine the as cast microstructure and improve the ...
Photochemical processes for removal of carbamate pesticides from water / Fotohemijski procesi za uklanjanje karbamatnih pesticida iz vode
(Univerzitet u Nišu - Tehnološki fakultet, Leskovac, 2019)
A large number of pesticide active ingredients have been registered and marketed for pest control purposes around the world. Most pesticides, including carbamates are resistant to chemical and natural photochemical ...
Anti-tarnish silver alloys in system ag-cu-zn-si with the addition of aluminum
(Association of Metallurgical Engineers of Serbia AMES, 2018)
This paper presents investigations of aluminum addition influence on the corrosion characteristics of the sterling silver Ag-Cu-Zn-Si alloys. The procedure for obtaining Ag-Cu-Zn-Al-Si alloys in small ranges of predefined ...
Micromechanical crack analysis of glass-epoxy laminated composites subjected to tension load / Mikromehanička analiza loma laminatnog staklo-epoksi kompozitnog materijala ispitivanog na zatezanje
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
The main objective of this study is to determine tensile properties of the glass-epoxy polymer composite material. The material is glass fiber 280 g/m², 'twill woven' with 100 cm width, type - Interglas 92125, and epoxy ...
Modelling of Dyeing of Modified Polyester at Lower Temperature by Ultrasound
(University of Ljubljani, Fac Natural Sci & Engineering, Dept Textiles, Ljubljana, 2018)
This article discusses the process of polyester dyeing through the modelling process, i.e. the ability of adsorption of dyes for chemically modified polyester fibres of knitted fabrics in aqueous environment in the presence ...
Preservation of vitamin C, lycopene and carbohydrate content in tomato dried in a tunnel type dryer / Očuvanje vitamina C, likopena i ugljenih hidrata u plodovima paradajza sušenim u tunelskom tipu sušara
(Institute for Food Technology, Novi Sad, 2017)
The aim of this study was to find an optimal way of tomato drying in a tunnel type dryer, in order to achieve the lowest possible losses in nutritive value of dried tomato products. Domestic variety of tomato (SP-109) was ...