Pretraživanje
Prikaz rezultata 61-70 od 178
Oxidation and erosion behaviour of SiC-HfC multilayered composite
(Univerzitet u Novom Sadu - Tehnološki fakultet, Novi Sad, 2014)
The fabrication of SiC-HfC ceramic composite via self-propagating high-temperature synthesis and simultaneous consolidation was investigated. Dense composite consisting of alternating layers of SiC and HfC was obtained by ...
Microstructural properties and cavitation behavior of hypereutectic Al-Si alloy obtained by rheocasting process / Mikrostrukturna svojstva i kavitaciono ponašanje nadeutektičke Al-Si legure dobijene reokasting postupkom
(Engineering Society for Corrosion, Belgrade, Serbia, 2014)
The purpose of this study was to investigate possible application of AlSi alloy produced by rheocasting process in cavitation conditions. A rheocasting process was used to refine the as cast microstructure and improve the ...
Modeling of disperse dye adsorption on modified polyester fibers
(University of Novi Sad, Faculty of Technology, 2020)
The results of the research on the ability of adsorption of dye on polyester fibers at a temperature of 98 °C are presented in this paper. The fibers were previously modified in aqueous solutions of NaOH, KOH or Al(OH)3. ...
Studying of physicochemical properties of newly synthesized uracil derivatives / Proučavanje fizičko-hemijskih svojstava novosintetisanih derivata uracila
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
Uracil derivatives are potentially biologically active compounds, so the investigation of their physical and chemical properties is very important for their further application. In this work a series of newly synthesized ...
Properties of cotton yarns after oxidation of potassium permanganate in an acidic environment / Svojstva pamučne pređe posle oksidacije kalijum-permanganatom u kiseloj sredini
(Engineering Society for Corrosion, Belgrade, Serbia, 2017)
The impact of nonselective cellulose oxidation (cotton fibre) by potassium permanganate in acidic environment, with or without additional treatment by sodium metabisulfite, on change of sorption (silver ions sorption), and ...
Investigation of copper(i) sulphide leaching in oxidative hydrochloric acid solution
(Savez inženjera metalurgije Srbije, Beograd, 2015)
Present work is focused on the copper (I) sulphide leaching with sodium chloride in hydrochloric acid solution and with introduction of gaseous oxygen. Chemical reactions of leaching and their thermodynamic probabilities ...
CO tolerant Pt/Ru0.7Ti0.3O2 nanocatalyst for hydrogen oxidation reaction / Pt/Ru0,7Ti0,3O2 kao nanokatalizator za oksidaciju vodonika i njegova tolerancija na CO
(Engineering Society for Corrosion, Belgrade, Serbia, 2018)
The oxidation of pure H2 and H2/CO mixture (100 ppm CO) was investigated on Pt nanocatalyst supported on Ru0.7Ti0.3O2 (Pt /Ru0.7Ti0.3O2) by linear sweep voltammetry at a rotating disc electrode in 0.1 M HClO4. The results ...
Application of raw volcanic rock found in etna valley as an adsorbent of chromates, arsenates and selenates
(Savez inženjera metalurgije Srbije, Beograd, 2018)
This paper aims to determine the potential of volcanic rock found in Etna valley as an adsorbent of heavy metals in anionic form (chromates, arsenates, and selenates). Characterization of the volcanic rock was done with ...
Synthesis of nife2o4 nanofibers by joint sol-gel and electrospinning technique
(Savez inženjera metalurgije Srbije, Beograd, 2018)
In this study, electrospinning combined with sol-gel technique is applied in order to produce magnetic nickel ferrite (Ni-ferrite) nanofibers. The prepared Ni-ferrite gel was mixed with poly(vinylpyrrolidone) (PVP) solution ...
Micromechanical crack analysis of glass-epoxy laminated composites subjected to tension load / Mikromehanička analiza loma laminatnog staklo-epoksi kompozitnog materijala ispitivanog na zatezanje
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
The main objective of this study is to determine tensile properties of the glass-epoxy polymer composite material. The material is glass fiber 280 g/m², 'twill woven' with 100 cm width, type - Interglas 92125, and epoxy ...