Pretraživanje
Prikaz rezultata 11-20 od 108
Electrochemical synthesis and corrosion behavior of thin polyaniline film on mild steel / Elektrohemijska sinteza i koroziono ponašanje tankih filmova polianilina na mekom čeliku
(Engineering Society for Corrosion, Belgrade, Serbia, 2003)
The electrochemical synthesis of polyaniline (PANI) on mild steel from the sodium-benzoate solutions has been investigated. It has been concluded that thin, highly adherent, polyaniline films could be obtained by anodic ...
The influence of hot-dip galvanized steel surface pretreatment on the adhesion of epoxy coating / Uticaj pripreme površine pocinkovanog čelika na adheziju epoksidne prevlake
(Engineering Society for Corrosion, Belgrade, Serbia, 2007)
The influence of hot-dip galvanized steel surface pretreatment on the adhesion of epoxy cataphoretic coating was investigated. Several passive films were formed on hot-dip galvanized steel (phosphate, chromate and oxide). ...
Characterization of electrochemically synthesized pani on graphite electrode for potential use in electrochemical power sources / Elektrohemijska sinteza i karakterizacija elektrode od polianilina za potencijalnu upotrebu u elektrohemijskim izvorima energije
(Inženjersko društvo za koroziju, Beograd, 2009)
Polyaniline (PANI) on graphite electrode was synthesized electrochemically under galvanostatic condition at current density of 2.0 mA cm-2 from aqueous solution of 1.0 moldm-3 HCl and 0.25 mol dm-3 aniline monomer. ...
Valorization of gallium from acidic zinc's liquor / Valorizacija galijuma iz kiselog cinkovog luga
(Engineering Society for Corrosion, Belgrade, Serbia, 2007)
In this paper are showed the results of valorisation of gallium, that is gallium salt gallium(III) chloride, GaCl3, by adsorption with chelate resin and then by extraction with 1, 5 mol/dm3 HCI to GaCl3. The efficiency of ...
Epoxy coatings electrodeposited on steel electrochemically modified by Zn-Co alloys / Epoksidne kataforetske prevlake na čeliku modifikovanom Zn-Co legurama
(Engineering Society for Corrosion, Belgrade, Serbia, 2003)
The corrosion behavior of epoxy coatings electrodeposited on steel and steel modified by Zn-Co alloys deposited from chloride and sulphate baths were investigated during exposure to 3 % NaCl. The electrochemical impedance ...
Corrosion studies on electrochemically deposited polyaniline and polyaniline/epoxy coatings on mild steel in acid sulfate solution / Koroziono ispitivanje elektrohemijski taloženog polianilina i polianilina/epoksi prevlaka na mekom čeliku u rastvoru sumporne kiseline
(Engineering Society for Corrosion, Belgrade, Serbia, 2004)
The corrosion behavior of mild steel, mild steel covered by electrochemically deposited polyaniline (PANI) film, epoxy coating and PANI/epoxy coating system in 0.1 M sulfuric acid solution, were investigated by electrochemical ...
Hydroxyapatite coatings on TiO2 nanotubes / Prevlake hidroksiapatita na nanotubama oksida titana
(Engineering Society for Corrosion, Belgrade, Serbia, 2010)
The aim of this work was to obtain nanotubular TiO2 layer by anodization of titanium substrate, and to prepare hydroxyapatite (HAP) coatings by electrophoretic deposition over nanotubular TiO2 layer. The presence of fluoride ...
Formation of approximate differential equations for electrical and molar conductivity determinations of sulfuric acid aqueous solution / Formiranje aproksimacionih diferencijalnih jednačina za određivanje električne i molarne provodljivosti vodenog rastvora sumporne kiseline
(Engineering Society for Corrosion, Belgrade, Serbia, 2005)
In this paper formation of linear differential equations for approximate determination of electrical and molar conductivity of sulfuric-acid solutions, has been give.
Influence of the synthesis procedures on pt catalyst activity for ethanol electrooxidation reaction / Uticaj postupka sinteze na aktivnost platinskih katalizatora za reakciju elektrooksidacije etanola
(Engineering Society for Corrosion, Belgrade, Serbia, 2016)
Carbon supported platinum catalysts for ethanol electrooxidation were synthesized by modified polyol synthesis method, assisted by microwave or reflux heating. Synthesized catalysts were characterized by XRD, STM and TGA ...
Impact of roughness of Zn-Mn coatings on corrosive stability / Uticaj hrapavosti Zn-Mn prevlaka na korozionu postojanost
(Engineering Society for Corrosion, Belgrade, Serbia, 2015)
This paper involves electrochemical deposition of Zn-Mn coatings from four solutions. We measured their roughness and corrosion stability. We used cathodes made of steel of unknown composition that were licensed under the ...