Search
Now showing items 61-70 of 900
Bulk etching rate of LR115 detectors
(Pergamon-Elsevier Science Ltd, Oxford, 2002)
The thickness of the layer of LR115 detector removed during etching was measured with a very precise instrument. Dependence of the bulk etch rate on temperature of the etching solution was investigated. It has been found ...
Facile fabrication of hybrid titanium(IV) isopropoxide/pozzolan nanosheets (TnS-Pz) of high photocatalytic activity: characterization and application for Cr(VI) reduction in an aqueous solution
(Springer Heidelberg, Heidelberg, 2021)
This paper presents the synthesis of a hybrid material through the use of natural pozzolan and titanium(IV) isopropoxide using the sol-gel method and its application in the photocatalytic hexavalent chromium reduction. The ...
Hydrogen evolution at Zn-Ni alloys
(Pergamon-Elsevier Science Ltd, Oxford, 1998)
Zn-Ni alloys were electrodeposited from a berate-citrate and TEPA bath in potentiostatic and galvanostatic regimes. Potential of electrodeposition or current density were varied and chemical composition and phase structure ...
Influence of periodate oxidation on sorption properties of viscose yarn
(Editura Acad Romane, Bucuresti, 2018)
Viscose yarn was submitted to oxidation using different sodium periodate concentrations for various periods of time in order to investigate the influence of oxidation on the chemical and sorption properties of the resulting ...
Electrooxidation of H-2, CO and H-2/CO mixtures on a well-characterized Pt-Re bulk alloy electrode and comparison with other Pt binary alloys
(Pergamon-Elsevier Science Ltd, Oxford, 1998)
We report new results for the electrooxidation of Hz, CO and H-2/CO mixtures on a Pt75Re25 bulk alloy using surface preparation in a UHV chamber and characterization by X-ray photoelectron spectroscopy (XPS). Sputter-cleaned ...
Titanium coated with high-performance nanocrystalline ruthenium oxide synthesized by the microwave-assisted sol-gel procedure
(Springer, New York, 2016)
Ruthenium oxide coating on titanium was prepared by the sol-gel procedure from well-defined colloidal oxide dispersions synthesized by the microwave (MW)-assisted hydrothermal route under defined temperature and pressure ...
Stress corrosion cracking susceptibility of Al-Mg alloy sheet with high Mg content
(Elsevier Science Sa, Lausanne, 2002)
Slow strain rate testing (SSRT) was used to study the effect of the microstructure on the stress corrosion cracking (SCC) susceptibility of Al-Mg alloy sheet containing 6.8 wt.% Mg. In the cold-rolled and fully annealed ...
Semi-IPNs based on polyacrylamide and poly(itaconic acid)
(Springer, New York, 2003)
Semi-IPNs based on polyacrylamide (PAAm) and poly(itaconic acid) (PIA) were prepared by two different techniques, polymerizing itaconic acid in the presence of polyacrylamide gel (Samples I) and by makiug the polyacrylamide ...
Adhesion and corrosion resistance of epoxy primers used in the automotive industry
(Taylor & Francis Ltd, Abingdon, 2007)
One of the most important factors in corrosion prevention by protective coatings is the loss of adhesion of the coating under environmental influence. Thus, adhesion strength is often used when characterizing protective ...
New analytical HFET I-V characteristics model
(Natl Inst Optoelectronics, Bucharest-Magurele, 2006)
In this paper the new analytical model of current - voltage characteristics of a Heterostructure Field Effect Transistor (HFET), is proposed. The model is relatively simple, and at the same time, it describes complex HFET ...