Претраживање
Приказ резултата 3441-3450 од 3474
Structural insight into the fiber dyeing ability: Pyridinium arylazo pyridone dyes
(Elsevier Ltd., 2021)
Herein, we report the synthesis and characterization of nine 6-hydroxy-4-methyl-3-pyridinium-2-pyridone based azo dyes, wherein, eight of them being novel. Used building blocks ensured water solubility of six dyes and made ...
High pressure densities and derived thermodynamic properties of deep eutectic solvents with menthol and saturated fatty acids
(Journal of Chemical Thermodynamics, 2021)
Densities of four Deep Eutectic Solvents (DESs) based on menthol and organic acids (menthol:octanoic acid (1:1), menthol:decanoic acid (1:1), menthol:dodecanoic acid (2:1) and decanoic acid:octanoic acid (1:3)) were measured ...
Reuse potential of functionalized thermoplastic waste as reinforcement for thermoset polymers: Mechanical properties and erosion resistance
(SAGE Publications Ltd., 2021)
Two types of polymer waste materials, poly(ethylene terephthalate) (PET) and polycarbonate based Colombian Resin (CR-39), were used for the designing of fully recycled composite materials. Waste PET was employed for the ...
Metal pollution index as a tool for assessing water quality of Boka Kotorska Bay
(Belgrade : Faculty of Agriculture, 2013)
Microstructure and cavitation erosion performance of nickel-Inconel 718 composite coatings produced with cold spray
(Elsevier Science Sa, Lausanne, 2020)
The cold spray technique was employed in this study to produce pure nickel (Ni) and nickel-Inconel 718 powder deposits on duplex stainless steel substrates. High quality coatings were manufactured using nitrogen as the ...
Adhesion testing of composites based on Bis-GMA/TEGDMA monomers reinforced with alumina based fillers on brass substrate
(Elsevier Sci Ltd, Oxford, 2018)
Quantitative assessment of the adhesion behavior between the composite film having UV cured Bis-GMA (Bisphenol A glycidylmethacrylate)/TEGDMA (triethylene glycol dimethacrylate) as matrix and the aluminum oxide based ...
Principal component analysis of morphological descriptors for monitoring surface defects induced by thermal shock
(Elsevier Ltd, 2021)
Pattern recognition techniques are applied to various morphological descriptors to monitor the formation and propagation of surface defects of materials subjected to thermal shock. A low-cement high-alumina castable was ...
The influence of alumina crystal structures on the morphology and surface erosion of PMMA composite materials exposed to cavitation testing
(Elsevier Science Sa, Lausanne, 2019)
Composites are materials that reach many users and therefore, it is necessary to correlate the properties of every component on the behaviour of the material. Alumina is used as reinforcement with the aim of improving ...
Valorization of corn stover and molasses for enzyme synthesis, lignocellulosic hydrolysis and bioethanol production by Hymenobacter sp. CKS3
(Environmental Technology & Innovation, 2021)
During the last few decades, energy demand is increasing rapidly. Concerning this, the use of renewables - lignocellulose biomass, for bioethanol production, as an efficient alternative to replacing fossil fuels, is highly ...
Halochromic cellulose textile obtained via dyeing with biocolorant isolated from Streptomyces sp. strain NP4
(Cellulose, 2021)
Halochromic (pH-responsive) material was obtained by dyeing functionalized viscose fabric with a crude extract from Streptomyces sp. strain NP4. The functionalization of the fabric before dyeing was performed to make ...