Претраживање
Приказ резултата 1-10 од 305
Effect of the thermo-mechanical treatment on IGC susceptibility of AA 5083 alloy
(Light Metals 2014 - TMS 2014 Annual Meeting and Exhibition, 2014)
This work reports on the effect of thermo-mechanical treatment on IGC susceptibility of the AA 5083 alloy. Specimens underwent varied amount of cold work and final annealing was conducted at 240°C. Extent of the cold work ...
The iron(III)-modified natural zeolitic tuff as an adsorbent and carrier for selenium oxyanions
(Elsevier, Amsterdam, 2014)
Se(IV) and Se(VI) anions are the dominant species of Se existing in aqueous systems. In this study, the iron(III)-modified natural zeolitic tuff (Fe-CLI) from the Serbian deposit Zlatokop has been investigated as an adsorbent ...
Analysis of trace elements in surface sediments, mussels, seagrass and seawater along the southeastern Adriatic coast - a chemometric approach
(Walter De Gruyter Gmbh, Berlin, 2014)
Surface sediments, mussels, seagrass, surface and bottom seawater samples were collected from the costal area of the southeastern Adriatic Sea and analyzed in order to determine the concentration and origin of the following ...
Application of gas chromatography analysis to quality control of residual organic solvents in clopidogrel bisulfate
(Serbian Chemical Society, 2014)
A direct-injection, split-mode capillary gas chromatographic procedure with flame ionization detection was developed for the analysis of eight solvents used in the synthesis and purification of the anti-thrombotic drug ...
Influence of the thermo-mechanical treatment on the exfoliation and pitting corrosion of an aa5083-type alloy
(Institute of Metals and Technology, 2014)
Exfoliation and pitting corrosion were tested on an AA5083-type alloy sheet, after applying different thermo-mechanical treatments. Hot-rolled plates were laboratory cold rolled with 16-54 % reductions, and subsequently ...
Influence of the Thermomechanical Treatment on the Intergranular Corrosion Susceptibility of Zn-Modified Al-5.1 Wt Pct Mg-0.7 Wt Pct Mn Alloy Sheet
(Springer, New York, 2014)
In this study, the effect of thermomechanical treatment on intergranular corrosion (IGC) susceptibility of the Zn-modified Al-5.1 wt pct Mg-0.7 wt pct Mn alloy plates was investigated. The specimens underwent varied amounts ...
Analysis of major, minor and trace elements in surface sediments by x-ray fluorescence spectrometry for assessment of possible contamination of Boka Kotorska Bay, Montenegro
(Macedonian Journal of Chemistry and Chemical Engineering, 2014)
Boka Kotorska Bay is on the UNESCO's World Heritage List. There are no published papers re-lated to the surface sediment pollution of the Bay. For the first time, elements were measured in surface sediments at nine locations ...
Crude bacterial extracts of two new Streptomyces sp isolates as bio-colorants for textile dyeing
(Springer, Dordrecht, 2014)
Renewed demand for incorporation of natural dyes (bio-colorants) in textile industry could be met through biotechnological production of bacterial pigments. Two new Streptomyces strains (NP2 and NP4) were isolated for the ...
Forecasting GHG emissions using an optimized artificial neural network model based on correlation and principal component analysis
(Elsevier Sci Ltd, Oxford, 2014)
The prediction of GHG emissions is very important due to their negative impacts on climate and global warming. The aim of this study was to develop a model for GHG forecasting emissions at the national level using a new ...
Biocomposite membranes of highly methylated pectin and mesoporous silica SBA-15
(Elsevier Ltd., 2014)
Manufacturing of synthetic composites consumes huge energy and their disposal at the end of the life cycle is very difficult since there is virtually no recycling option. Therefore, biocomposite materials have recently ...