Претраживање
Приказ резултата 11-20 од 39
Optimization of the extraction of antioxidants from stinging nettle leaf using response surface methodology
(Macedonian Journal of Chemistry and Chemical Engineering, 2022)
The aim of this study was to optimize the parameters for the extraction of total flavonoids from stinging nettle leaf. Comparison of the effects of different solvents on total flavonoid content showed that, regardless of ...
Manifestations of dynamic strain ageing in 2090 Al-Li alloy
(International Journal of Materials Research, 2022)
The manifestations of dynamic strain ageing in a commercial 2090 Al - Li alloy were investigated in a wide range of temperatures (-40 to 100 degrees C) and strain rates (4.16x10(-5) to 4.16x10(-3) s(-1) ). Serrated yielding, ...
Macrophages, the main marker in biocompatibility evaluation of new hydrogels after subcutaneous implantation in rats
(Journal of Biomaterials Applications, 2022)
Biocompatibility of materials is one of the most important conditions for their successful application in tissue regeneration and repair. Cell-surface interactions stimulate adhesion and activation of macrophages whose ...
Ultrasound-assisted extraction of essential and toxic elements from pepper in different ripening stages using Box–Behnken design
(John Wiley and Sons Inc., 2022)
The influence of extraction parameters on the ultrasonically assisted extraction (UAE) of K, Na, Ca, Mg, Zn, Cu, Fe, Mn, Cr, Se, Mo, Li, Al, B, Pb, Hg, Cd, As, and Ni was studied to determine the conditions when a minimum ...
Disparate soil textures as a native medium for As(V) and Pb(II) separation from aqueous systems
(Desalination Publications, 2022)
This study investigated the use of different natural raw soil materials as low-cost adsorbents for
the removal to remove As(V) and Pb(II) from aqueous systems. It deals with the effect of different soil textures, sandy ...
Processing of Data Obtained by the Testing of Steel under Low Cyclic Fatigue (Part I)
(University of Zagreb Faculty of Mechanical Engineering and Naval Architecture, 2022)
The design of mechanical components exposed to fatigue load, at a low number of cycles, requires knowledge of the behaviour of the material under the impact of variable load in conditions of controlled strain when cyclic ...
Synthesis of the new lost foam refractory coatings based on talc
(Journal of the Serbian Chemical Society, 2022)
This paper is focused on the preparation procedures, using a talc-based filler, to improve the rheologic properties of the lost foam refractory coatings. Talc, with grain size of 40 .m, was mechanically activated in a ...
Desulphurisation of dibenzothiophene and 4,6 – dimethyl dibenzothio-phene via enhanced hydrogenation reaction route using RePd–TiO2/SiO2 aerogel catalysts: Kinetic parameters estimation and modelling / Desulfurizacija dibenzotiofena i 4,6 – dimetildibenzotiofena procesom hidrogenovanja uz korišćenje RePd–TiO2/SiO2 aerogel katalizatora: proračun kinetičkih parametara i simulacijaprocesa
(Association of the Chemical Engineers of Serbia, 2022)
Re/Pd-TiO2/SiO2 aerogel catalysts were synthesized by using a sol-gel method and supercritical drying in excess solvent and investigated in the reaction of hydrodesulphurisation (HDS) of dibenzothiophene (DBT) and 4,6-dimethyl ...
Direct Electrochemical Degradation of Carbamate Pesticide Methomyl Using IrOX Anode
(ESG, 2022)
The study's primary goal is to determine carbamate pesticide methomyl's kinetic parameters and degradation efficiency from water solution by direct electrochemical oxidation using IrOX anode. Also, define the dependence ...
Ticagrelor Determination via Its Electrooxidation as the Standard, in Tablets and the Spiked Human Serum at Au Solid Electrode
(ESG, 2022)
Ticagrelor hydrochloride (TCG) is effective in platelet inhibition and useful for preventing cardiovascular death, myocardial infarction, or ischaemic stroke. The drug standard was investigated by cyclic voltammetry (CV) ...