Претраживање
Приказ резултата 1-10 од 62
Corrosion behaviour of epoxy coatings investigated by EIS
(Trans Tech Publications Ltd, Durnten-Zurich, 1998)
Epoxy coatings were formed by cathodic electrodeposition of an epoxy resin on steel and on electrochemically modified steel surface by Fe-P alloy using constant voltage method (resin concentration 10 wt.%, temperature 26 ...
Electrodeposition and characterization of Fe-Mo alloys as cathodes for hydrogen evolution in the process of chlorate production / Elektrohemijsko taloženje i karakterizacija Fe-Mo legura kao katoda za reakciju izdvajanja vodonika u industrijskom procesu proizvodnje hlorata
(Serbian Chemical Society, Belgrade, 2005)
Fe–Mo alloys were electrodeposited from a pyrophosphate bath using a single diode rectified AC current. Their composition and morphology were investigated by SEM, optical microscopy and EDS, in order to determine the ...
Cross-section analysis of the morphology of electrodeposited copper obtained in the hydrogen co-deposition range / Morfologija poprečnog preseka prevlaka bakra dobijenih elektrohemijskim taloženjem u oblasti ko-depozicije vodonika
(Serbian Chemical Society, 2009)
Cross-section analysis of copper deposits electrodeposited in the hydrogen co-deposition range at a constant overpotential and in a pulsating overpotential (PO) regime was performed. It was shown that a complete structural ...
Epoxy coatings electrodeposited on aluminium and modified aluminium surfaces / Epoksidne kataforetske prevlake na aluminijumu i modifikovanim površinama aluminijuma
(Association of Chemical Engineers of Serbia, 2002)
The corrosion behaviour and thermal stability of epoxy coatings electrodeposited on modified aluminum surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) were monitored during exposure to 3% NaCl ...
Electrophoretic deposition of thin alumina films from water suspension
(Elsevier, Amsterdam, 2002)
Alumina water suspensions have been prepared for thin alumina film deposition on steel. The type and quantity of deflocculant have been determined using zeta potential and viscosimetric measurements. The deposition was ...
Electrodeposition of silver from nitrate solution: Part II. Mechanism of the effect of phosphate ions
(Springer, Dordrecht, 1998)
The mechanism of compact Ag-film formation by electrolysis from nitrate solution with addition of small amounts of phosphate ions is elucidated. It is shown that the phosphate ions exert their effect by lowering the exchange ...
Determination of the protective properties of electrodeposited organic epoxy coatings on aluminium and modified aluminium surfaces
(Pergamon-Elsevier Science Ltd, Oxford, 2005)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on aluminium and modified aluminium surfaces (anodized, phosphatized and chromatized-phosphatized aluminium) have been ...
Hardness response and adhesion of thin copper films on alloy substrates
(Belgrade: ETRAN – Society for electronics, telecommunication, computing, automatics and nuclear engineering, 2017)
Microhardness test is the most commonly used method for assessing the mechanical properties of thin films.This testing method uses controlled contact at a single point of an indenter and chosen material which induces the ...
Corrosion behaviour of epoxy coatings electrodeposited on galvanized steel and steel modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2000)
The electrochemical and transport properties and thermal stability of epoxy coatings electrodeposited on hot-dip galvanized steel and steel modified by Zn-Ni alloys were investigated during exposure to 3% NaCl solution. ...
Protective properties of epoxy coatings electrodeposited on steel electrochemically modified by Zn-Ni alloys
(Elsevier Science Sa, Lausanne, 2004)
A review is given on Zn-Ni alloys electrochemically deposited on steel under various deposition conditions. The influence of deposition current density and type of deposition solution on the chemical content, phase structure ...