Претраживање
Приказ резултата 1-10 од 330
Digest of the round table titled "Medicine and engineering: An inexhaustible source of challenges for cooperation between medical doctors and engineers"
(Srpski Arhiv Za Celokupno Lekarstvo, 2021)
The influence of different extraction conditions on polyphenol content, antioxidant and antimicrobial activities of wild thyme
(Journal of Applied Research on Medicinal and Aromatic Plants, 2021)
The aims of the presented study were the investigation of the effect of different ultrasound-assisted extraction conditions (particle size, solid-to-solvent ratio, ethanol concentration and time) on polyphenol and flavonoid ...
Algorithm for quantifying the particle size distribution of non-metallic inclusions formation in steel production
(Metallurgical & Materials Engineering, 2021)
When the quantitative characterization of non-metallic inclusions in steel is done and the effect of limiting factors is assessed, and based on that the possibility of reconstruction of the total content of non-metallic ...
Estimation of radiological impact on residents due to household storage of coal used for heating in Serbia
(Nuclear Technology & Radiation Protection, 2021)
This pa per aims to es ti mate a po ten tial ra dio log i cal risk from dif fer ent kinds of coals used for do mes tic heat ing in Ser bia, by mea sur ing the ac tiv ity con cen tra tion of radionuclides and ra don ex ha ...
Optimization of spray drying conditions for production of Achillea millefolium extract powder
(Hemijska industrija, 2021)
In this study, a spray drying process of yarrow (Achillea millefolium L.) liquid extracts was optimized by using the response surface methodology. The study aimed to determine the influence of temperature (120-195 degrees ...
Estimation of phosphorus distribution ratio at the end of blowing in bof
(Metallurgical & Materials Engineering, 2021)
In integrated steel plants, the removal of phosphorous normally takes place during the primary basic oxygen furnace (BOF) steelmaking process. Phosphorous is usually introduced to the integrated steelmaking process through ...
Ceria Particles as Efficient Dopant in the Electrodeposition of Zn-Co-CeO2 Composite Coatings with Enhanced Corrosion Resistance: The Effect of Current Density and Particle Concentration
(Molecules, 2021)
Novel Zn-Co-CeO2 protective composite coatings were deposited successfully from chloride plating solutions. Two different types of ceria sources were used and compared: commercial ceria powder and home-made ceria sol. ...
Adsorption of Anthraquinone Dye AB111 from Aqueous Solution using Synthesized Alumina-Iron Oxide Doped Particles
(Science of Sintering, 2021)
Adsorption of anthraquinone dye Acid Blue 111 by alumina-iron oxide doped particles prepared by sol-gel method from aqueous solutions was studied. The adsorbent morphology was revealed by FESEM and the crystallographic ...
Volumetric and thermodynamic properties of binary mixtures of p-cymene with alpha-pinene, limonene and citral at atmospheric pressure and temperatures up to 323.15 K
(Journal of Molecular Liquids, 2021)
An experimental analysis of density, refractive index, speed of sound and the viscosity at atmospheric pressure and temperatures T = (288.15 to 323.15) K has been carried out for the three binary systems, i.e. (p-cymene + ...
Global market trends of tantalum and recycling methods from Waste Tantalum Capacitors: A review
(Sustainable Materials and Technologies, 2021)
The rapid digitalization of the world, technological up-gradation, and shorten life cycle of electronic gadgets leading to the generation of an enormous amount of waste tantalum capacitors (WTCs) rich in tantalum every ...