Pretraživanje
Prikaz rezultata 11-20 od 39
Optimized preparation of alumina based fillers for tuning composite properties
(Elsevier Sci Ltd, Oxford, 2018)
Alumina based particles were prepared from aluminium chloride hydroxide as starting material by sol-gel technique. One series of particles was doped with ferrous oxide. Both series of particles were calcinated at three ...
Aramid hybrid composite laminates reinforced with inorganic fullerene-like tungsten disulfide nanoparticles
(Elsevier Sci Ltd, Oxford, 2017)
Combination of phenolic resin with poly (vinyl butyral), PVB, is often used as impregnation of aramid fabrics in prepregs for the ballistic protection products. In this study an effect of inorganic fullerene-like tungsten ...
Composite materials from fully bio-based thermosetting resins and recycled waste poly(ethylene terephthalate)
(Elsevier Sci Ltd, Oxford, 2018)
During the last two decades, interest in bio-based polymers, especially in bio-based composite materials, has grown as a result of environmental concerns. In this paper new composites obtained from fully bio-based unsaturated ...
Mg/Cu co-substituted hydroxyapatite - Biocompatibility, mechanical properties and antimicrobial activity
(Elsevier Sci Ltd, Oxford, 2019)
The aim of this study was to improve the mechanical properties and to optimize antimicrobial activity of hydroxyapatite (HAP) by simultaneous doping with Mg and Cu ions in order to obtain material that would be able to ...
Preparation, characterization and mechanical properties of Bi12SiO20-PMMA composite films
(Elsevier Science Sa, Lausanne, 2014)
This paper investigates processing and characterization of polymer composite material PMMA-Bi12SiO20 (BSO). Thin films of pure PMMA and composites with 0.5 and 1.0 wt% of Bi12SiO20 powder were made using solution casting ...
Multi-level finite element analysis for progressive damage behavior of HA/PEEK composite porous structure
(Elsevier Sci Ltd, Oxford, 2013)
A three-dimensional multi-level finite element (FE) modeling approach has been developed to simulate mechanical response and progressive damage behavior of hydroxyapatite/polyetheretherketone (HA/PEEK) porous structures ...
Quantitative evaluation of sulfur-polymer matrix composite quality
(Elsevier Sci Ltd, Oxford, 2013)
In order to predict service life of the sulfur polymer composite, the samples were subjected to the induced destruction using 10% hydrochloric acid solution. Control specimens were prepared using Portland cement binder. ...
Improvement of mechanical properties and antibacterial activity of crosslinked electrospun chitosan/poly (ethylene oxide) nanofibers
(Elsevier Sci Ltd, Oxford, 2017)
In this study conditions for green crosslinking with citric acid of chitosan/PEO (polyethylene oxide) nanofibers were evaluated. The thermal in situ crosslinking enabled penetration of crosslinking agent into the matrix ...
Microstructure and mechanical properties of Al-4·4 wt-%Mg alloy (AA5182) after equal channel angular pressing
(Maney Publishing, 2005)
Equal channel angular pressing (ECAP) has been used to process an Al-4-4 wt-%Mg alloy (AA5182) at room temperature (RT), 200°C and 400°C. The evolution of microstructure and mechanical properties after ECAP has been studied ...
Improvement of the mechanical properties of paper by starch coatings modified with sepiolite nanoparticles
(Wiley-VCH Verlag Gmbh, Weinheim, 2015)
The modern and rapidly developing paper and board industry requires more efficient agents for the surface of paper in order to improve the mechanical properties. The starch coating used for the reinforcement of schrenz ...