Претраживање
Приказ резултата 21-30 од 851
Cross-linking the peroxidase: From potato peel valorization to colored effluents treatment
(Institute of Physics, 2022)
Despite the obvious benefits from mass production such as an increased productivity, lower product cost and rapid evolution, nowadays we are dealing with energy consumption issues and pollution. The generated waste poses ...
Impact of Crosslinking on the Characteristics of Pectin Monolith Cryogels
(MDPI, 2022)
In this research, the pectin monoliths were prepared via the sol-gel process through different routes of crosslinking and additional freeze-drying. The crosslinking reaction was induced by the use of calcium ions in aqueous ...
Effect of the Degree of Conversion on Mechanical Properties and Monomer Elution from Self-, Dual- and Light-Cured Core Composites
(Materials, 2021)
The objective of this work was to measure and correlate the degree of conversion (DC), mechanical properties and monomer elution from self-, dual- and light-cured core composites. Five samples of each of the following ...
Towards enhanced dyeing process: arylazo pyridone dyes / Poboljšanje procesa bojenja iz perspektive arilazo piridonskih boja
(Beograd : Savez mašinskih i elektrotehničkih inženjera i tehničara Srbije (SMEITS), Društvo za procesnu tehniku, 2020)
Azo pyridone dyes as a group of synthetic disperse azo dyes are commonly used in textile fiber dyeing. Traditionally, synthetic fibers are tinted in an acid environment, whereas their stability has been ruptured by base ...
Cavitation resistance of the material PA 3200 GF produced by selective laser sintering
(International Institute for the Science of Sintering (IISS), 2023)
The present study focuses on the results of cavitation resistance research of samples obtained by the Selective Laser Sintering technology. The samples were made from polyamide powder reinforced with glass beads – PA 3200 ...
An Efficient Electrochemical Sensing of Caffeic Acid at Thermolysis Prepared Urea-formaldehyde Resin Modified with Fe(III) and Ti(IV) Oxide Particles
(Electrochemical Science Group, 2022)
Urea-formaldehyde resin (UF) is primarily used as an adhesive applied in the wood composites industry. In this work, we found that this resin modified with metal compounds could be a good starting point to produce ...
Interdisciplinary crossover for rapid advancements - collaboration between medical and engineering scientists with the focus on Serbia
(Srpski Arhiv Za Celokupno Lekarstvo, 2021)
Over the past decades, development of engineering sciences has vastly contributed to advancements in medicine by production of numerous devices for diagnostics and treatment. In the middle of the 20th century, a new ...
Antimycobacterial and anticancer activity of newly designed cinnamic acid hydrazides with favorable toxicity profile: Antimycobacterial and anticancer activity of newly designed cinnamic acid
(Arabian Journal of Chemistry, 2022)
A series of twelve novel hybrids of cinnamic acid and thiocarbohydrazones were designed, synthesized in high yield using a simple coupling strategy via acid chlorides, and evaluated for their impact against Mycobacterium ...
Radon and thoron exhalation rate measurements from building materials used in Serbia
(Nukleonika, 2020)
The second most important source of indoor radon, after soil beneath dwelling, is building material. With the increase in environmental awareness and new energy-saving policies, residents tend to replace the existing windows ...
OPTIMALITY CONDITIONS FOR ISOPERIMETRIC CONTINUOUS-TIME OPTIMIZATION PROBLEMS
(Faculty of Organizational Sciences, Belgrade, 2023)
In this paper we deal with a nonsmooth case of isoperimetric convex continuoustime programming problem with inequality integral constraint and phase constraint, defined in L∞([0, T],Rn). In order to obtain necessary ...